User manual VIVANCO UR 89

[. . . ] Instead of the TV appliance button, press another button e. Code search If the brand of your appliance is not in the list or none of the codes given fits, we recommend a code search. To prepare code search, press the SET button, keep it pressed and then press the required appliance button, e. TV, additionally until the lamp (LED) lights constantly. [. . . ] - If you notice the reaction of your appliance too late and the next code has already been emitted you can go back by pressing SET and then ON/OFF or Play again. If your appliance has switched itself off you must switch it back on again, e. - When your appliance reacts you can also try out other buttons without interrupting the search. If some buttons do not work properly, simply continue searching with ON/OFF or Play. - The UR 810 continues with the search at the point where you interrupted it. When the end of the code list is reached the search stops automatically. Automatic code search Your remote control finds the correct settings almost automatically in seconds: 1. switch on the appliance to be controlled. A channel number, for example, appears in the display of your satellite receiver. To start the code search, press the SET button, and then additionally the required appliance button, e. TV, for more than 3 seconds until the lamp (LED) starts to blink. The DVD device key starts blinking indicating that DVD key codes (functions) can be captured. 4 Press and release the target key, that you want to learn to (reprogram) (e. DVD) on your UR 810 remote control blinks twice, then lights up for 2 seconds and then starts blinking again. - If there is a learning(capturing) problem, the LED blinks 4 times, lights up for 2 seconds and then will start blinking again. Then start capturing the key function again at step 4. 7 Press and release device key for exit of learning mode. ­ The controller will exit the learning mode automatically after about 30 seconds of inactivity. Reset/deletion of all captured key functions per device: press the right device selection key, e. DVD, and then SET and 4 together in order to delete all learnt functions. The appropriate device key LED will flash twice for confirmation. Memory full indication: if the memory is full, a LED blink 4 times and then the controller will exit learnning mode. [. . . ] Assigning volume and mute exclusively to one appliance (punch through function: Press the appliance button of the appliance that you always want to use for volume control, e. Device Selection Key Shift: In order to change the function of a device selection key, e. Change device key AUX1 to a second SAT device key proceed as follows: a) Press SET hold it and then press the to be changed device key, e. Then release both keys and the AUX1 light will be on. [. . . ]