User manual VIVITAR VIVICAM 3315

[. . . ] Vivicam 3315 User Manual English. 1 digital camera user's manual Warranty Policy This camera is under warranty for one full year from the date of purchase by the original purchaser. In case of defects in materials or workmanship we will, at our discretion, will repair or replace the camera free of charge. This warranty applies to the camera only. This warranty does not include batteries, software, or other accessories which have not been manufactured by Vivitar. [. . . ] Use the arrow buttons and Record icons: to scroll forward/backward through the recorded images To Playback Images on a TV 1. Set the appropriate Video output (NTSC/PAL) corresponding to your TV standard 2. Connect one end of the video cable to the "VIDEO OUT" port of your camera 3. Connect the other end of the cable to a VIDEO IN port of your television or monitor 4. Press the Mode button to select the Play Mode, as described above 6. Use the arrow buttons to scroll forward/backward through the recorded images Video Playback 1. Press the Mode button to select the Movie Play Mode as indicated by arrows pointing at both the Play and Movie icons: 3. Use the arrow button to scroll forward/backward through the recorded videos 5. Press shutter button once to start a video playback 6. To pause/resume the playback, press shutter button once again Erasing Still Images There are two ways to erase (delete) images: * Erase One * Erase All ERASE MENU ERASE ONE ERASE ALL Note * Images recorded images on a memory card cannot be erased if it is write-protected * To erase images on an SD card, make sure to insert the card before deletion * To erase images recorded in the cameras internal memory, do not insert an SD card * External memory (SD card) always has priority over internal memory - whenever a memory card is inserted into the camera the camera will use the memory card for both capture and playback 12 ERASE CURRENT IMAGE 1. Press the Mode button to select the Still-Image Play Mode (see prior page) 2. The last image taken will be shown on LCD image display 3. Press the Menu button to enter the PLAY MENU 4. Use the arrow buttons to highlight ERASE, press OK ERASE CURRENT? 5. "ERASE CURRENT?" will be displayed in the center of the image: 7. Press the OK button to move to the "ERASE CURRENT" menu 8. "ERASE IMAGE NUMBER xxxx?" will be displayed: 9. Press the OK to delete this image ERASE CURRENT ERASE IMAGE NUMBER 00003?Follow steps 1 through 4 in the preceding section 2. Use the arrow buttons to highlight ERASE ALL, press OK to highlight YES, press OK ERASE ALL ARE YOU SURE?The "ERASE ALL" menu appears: * If there are no images stored in the memory "NO IMAGE" is displayed Erasing a Video To erase a video: 1. Press the Mode button to select the Movie Play Mode (see prior page) 2. [. . . ] NTSC TV or PAL TV). VIDEO MODE NTSC PAL USB CONFIGURATION The V3315 supports two USB modes: DISK DRIVE and SILENT VIDEO. DISK DRIVE: This mode is to transfer pictures to your PC SILENT VIDEO: For PC camera mode USB CONFIG DISK DRIVE SILENT VIDEO AUTO POWER OFF The camera will turn off automatically after no-operation or 90 seconds. You may specify a power-off time of: 3, 5, 10, or 30 minutes. AUTO POWER OFF 3 Min 5 min 10 Min 30 Min Cancel LIGHT FREQUENCY The V3315 supports different lighting frequencies: 50HZ and 60HZ. Select the correct frequency for your region. LIGHT FREQUENCY 50HZ 60HZ PC Mode Images can only be transferred to your PC via USB in DISK DRIVE mode. [. . . ]