User manual VOLTA U1122

[. . . ] · Extend the cable and connect to mains. The Elyps is fitted with cable rewind, ensure cable is not twisted before use. [. . . ] Dust bag indicator and changing the dust bag For peak performance the dust bag must be changed when full. If the dust bag breaks in thee cleaner, the Elyps must be taken to an Authorised Service for cleaning. The dust bag indicator window will gradually turn red when filling and completely red when full. To check the dust bag, the cleaner must be switched on, with all attachments connected and off the floor. The dust bag full indicator may signify that the bag is blocked (occasionally caused by very fine dust) which will cause loss of suction and may result in overheating. If this occurs change the dust bag even if it is not full. To change the dust bag: A Release catch and swing back lid before removing the dust bag, bend the tab into the hole to prevent dust escaping. C Insert new dust bag by fitting the bag slots over holders. We recommend the dust bag is changed: * after using a carpet cleaning powder * if there is a bad smell from the cleaner, then you should also change the filter Note: Use only original dust bags and filters Dust bag safety device To avoid damaging the cleaner do not use it without a dust bag. A safety device is fitted which prevents the cover closing without a dust bag. Changing the filters These should be changed every fifth dust bag. Never use the cleaner without the motor protection filter. [. . . ] If the safety valve triggers repeatedly during normal use, check and remedy any blockage in the hose, tubes, nozzle or filters. The clearing of blocked hoses is not covered by the guarantee. [. . . ]