User manual VOLTA U4402

[. . . ] Volta reserve the right to alter product appearance and/or specifications without notice. Not all models featured are available in all countries. Volta vacuum cleaner features and accessories are protected worldwide by Patents or Registered Designs. E Tack för att du valde en dammsugare från Volta. För att uppnå bästa städresultat, läs denna instruktionsbok noggrant. [. . . ] Please hold the plug to prevent it striking you). Before using the appliance, unwind a sufficient length of cable and insert the plug into the power socket. A YELLOW mark on the power cable shows the ideal cable length. Do not extend the cable beyond the RED mark. 5 Press the on/off button to start the cleaner. Accessories Dustbag Swivel hose and handle with manual suction control Telescopic tube Combination carpet/hard floor nozzle Combination crevice nozzle/ brush Upholstery nozzle Ensuring your safety The cleaner is for domestic use only and has been designed to ensure maximum safety and performance. Please follow these simple precautions: The cleaner is double insulated so it must not be earthed The cleaner is only to be used by adults Do not pick up very fine dust (plaster, cement, cold cinders. . . ) Always store in a dry place Do not use to pick up liquids Avoid sharp objects Do not pick up hot cinders or lighted cigarette ends Do not use near flammable gases Avoid tugging on the mains cable and check cable regularly for damage Note: Do not use cleaner with a damaged cable. If the cable is damaged, it hould be replaced at a service centre The plug must be removed from the socket-outlet before cleaning or maintaining the appliance All service and repairs must be carried out by authorised service staff A B C D E F G H I J K 6 To increase/decrease suction, adjust the rolling wheel control. Suction can also be regulated on the hose handle by opening/closing the vent. Features of the vacuum cleaner Mains cable Cable rewind button Mechanical dustbag full indicator Hose connection Carrying handle Cover release catch for dustbag compartment Cover release for accessory compartment On/off button Parking position for nozzle when in use Storage slot for nozzle when not in use Suction control regulator Getting the best results Carpets: Use floor nozzle with lever in this position. Hard floors: Use floor nozzle with lever in this position. Loose rugs/curtains/lightweight fabrics: Reduce the suction power. Use the floor nozzle for loose rugs and the upholstery nozzle for curtains, cushions etc. Confined areas: Use the crevice nozzle for tight corners and radiators etc. U4401, U4402 2 Dustbag indicator and changing the dustbag For peak performance the dustbag should be changed when full. The mechanical dustbag indicator window will gradually turn red when filling and completely red when full. If the dustbag should get broken in the cleaner, take cleaner to service centre for cleaning. The dustbag full indicator may signify that the bag is blocked (occasionally caused by finer dust) which will cause loss of suction and may result in overheating. If this occurs change the bag even if it is not full. DO NOT VACUUM VERY FINE DUST (PLASTER, CEMENT, COLD CINDERS. . . ). To check the dustbag, the cleaner must be switched on, with all attachments connected but the nozzle does not have to be placed on the floor. To change the dustbag 7 Open the cleaner cover. 9 Adjust the upper part of the dustbag into the dustbag compartment. [. . . ] Clear blockage and/or replace filter(s) and restart. The clearing of blocked hoses is not covered by the guarantee. To avoid blockages and maintain suction efficiency, the floor nozzles should be cleaned regularly using the hose handle. Please see additional Volta information towards the back of this booklet. [. . . ]