User manual VOLTA U6200

[. . . ] 2 3 Getting Started 1Check the s-bag TM is in place. Insert the hose until the catches click to engage (press catches inwards to release). [. . . ] The s-bag TM full indicator may signify that the bag is blocked (occasionally caused by finer dust) which will cause loss of suction and may result in overheating. If this occurs change the bag even if it is not full. DO NOT VACUUM VERY FINE DUST (PLASTER, CEMENT, COLD CINDERS. . . ). To check the dustbag, the cleaner must be switched on, with all attachments connected but the nozzle does not have to be placed on the floor. To change the s-bagTM: 7 Open the cleaner cover. 8 Remove the s-bag TM holder and pull the sliding tab to remove the sbagTM from its holder. 9 Insert the new s-bagTM by sliding the bag slots into the holder. 10 Make sure that the dustbag (s-bag TM) is not overlapping with the rubber sealing. (Push downwards before inserting the dustbag holder into the dustbag compartement) We recommend the s-bag TM is changed after using a carpet cleaning powder or if there is a bad smell from the cleaner. Note: Only use original s-bags TM and filters s-bag TM (ref. D09) s-bagTM safety device To avoid damaging the cleaner, do not use it without a dust bag. A safety device is fitted which prevents the cover closing without a dust bag in place. Changing/cleaning the filters Never use the cleaner without the filters in place. The filters should be changed/cleaned approximately every fifth dust bag. [. . . ] The clearing of blocked hoses is not covered by the guarantee. To avoid blockages and maintain suction efficiency, the floor nozzles should be cleaned regularly using the hose handle. [. . . ]