User manual VOLTA U6205

[. . . ] 2 Insert the hose until the catches click to engage (press catches inwards to release). 3 Attach extension tubes or telescopic tube (some models) to the hose handle and floor nozzle and twisting them together (twist and pull apart to dismantle). [. . . ] DO NOT VACUUM VERY FINE DUST (PLASTER, CEMENT, COLD CINDERS. . . ). To check the dustbag, the cleaner must be switched on, with all attachments connected but the nozzle does not have to be placed on the floor. To change the s-bagTM: 7 Open the cleaner cover. 8 Remove the s-bagTM holder and pull the sliding tab to remove the sbagTM from its holder. 9 Insert the new s-bagTM by sliding the bag slots into the holder. 10 Make sure that the dustbag (s-bagTM) is not overlapping with the rubber sealing. (Push downwards before inserting the dustbag holder into the dustbag compartment) We recommend the s-bagTM is changed after using a carpet cleaning powder or if there is a bad smell from the cleaner. Note: Only use original s-bagsTM and filters s-bagTM (ref. D09) s-bagTM safety device To avoid damaging the cleaner, do not use it without a dustbag. A safety device is fitted which prevents the cover closing without a dustbag in place. Changing/cleaning the filters Never use the cleaner without the filters in place. The filters should be changed/cleaned approximately every fifth dustbag. [. . . ] The clearing of blocked hoses is not covered by the guarantee. To avoid blockages and maintain suction efficiency, the floor nozzles should be cleaned regularly using the hose handle. [. . . ]