User manual VOLTA U7510

[. . . ] Micro sistemi U7510 composto da U7510 (apparecchio principale) e CP-HP500H (sistema di diffusori). U7510 micro systeem bestaande uit U7510 (hoofdtoestel) en CPHP500H (luidsprekersysteem). U7510 Sistema de Micro Componente composto de U7510 (unidade principal) e CP-HP500H (sistema de alto-falante). U7510 Micro Component System consisting of U7510 (main unit) and CP-HP500H (speaker system). U7510 BEDIENUNGSANLEITUNG MODE D'EMPLOI MANUAL DE MANEJO BRUKSANVISNING MANUALE DI ISTRUZIONI GEBRUIKSAANWIJZING MANUAL DE OPERAO OPERATION MANUAL DEUTSCH FRANAIS ESPAOL SVENSKA ITALIANO NEDERLANDS PORTUGUS ENGLISH Siehe Seiten i bis vi und D-1 bis D-32. [. . . ] Playback will begin from track 1 on the DISC 1. After that disc finishes playing, the next disc will automatically play. When the last track on the third disc has finished playing, the CD player will stop automatically. When there is no CD in one of the disc tray 1 - 3 positions, that position will be skipped and the next CD will be played. CD Playback 1 2 3 4 Press the ON/STAND-BY button to turn the power on. Press the button to open the disc tray 1. To interrupt playback: Press the CD button on the remote control. To resume playback from the same point, press the To stop playback: Press the (CD ) button. button. Place the CD on the disc tray 1, label side up. Be sure to place 8 cm (3") CD in the middle of the disc trays. 12 cm (5") 8 cm (3") To exchange other CDs whilst playing a disc: Press the button for the stopped disc and exchange discs. To remove the CDs: Whilst in the stop mode, press the desired button. E-11 02/7/23 U7510(H)E2. fm U7510 " To locate the beginning of a track To move to the beginning of the next track: Press the button for less than 0. 5 seconds during playback. To restart the track being played: Press the button for less than 0. 5 seconds during playback. You can locate the beginning of a track on a single disc only. You can skip to any track by pressing the repeatedly until the desired track number appears. " To specify a disc to play You can play a disc by specifying the disc number. To repeat desired tracks: Perform steps 1 - 6 in the "Programmed play" section and then press the / button twice. To cancel repeat play: Press the / button again. " " will go out. CD Playback A. For example, to choose 13 1 Press the "+10" button once. For example, to choose 30 1 Press the "+10" button three times. If the direct search buttons are pressed whilst the disc is stopped, press the / button to start the desired track on the current disc. A track number higher than the number of tracks on the disc cannot be selected. During random play, direct search is not possible. " Random play The tracks on the disc(s) can be played in random order automatically. To random play all tracks on up to 3 discs: 1 Press the / button. 2 Press the RANDOM button on the remote control. To random play all tracks on the chosen disc: 1 Press one of the DISC SELECT - ( 1 - 3) buttons. [. . . ] Is the unit located near excessive skipped, or stopped in the vibrations?Has condensation formed inside the unit? E-29 02/7/23 U7510(H)E3. fm U7510 " Remote control Symptom !! " Clearing all the memory (reset) Possible cause Is the AC power lead of the unit plugged in?Does the remote control sensor receive strong light? [. . . ]