User manual VOLTA W6030

[. . . ] This cleaner should only be used for its intended purpose as described in these instructions. Never operate the vacuum cleaner without filters. DO NOT pick up hard or sharp objects, matches, hot ashes, cigarette ends or similar items. [. . . ] If still inoperative, contact service agent. Replace dust-bag, remove objects from hose, wand, replace filters. Switch on, press reset-button, have belt replaced by service agent. REMEDY Due to our program of continuous product improvement and innovation, sometimes the product you buy may differ slightly from the one shown on this product carton 4 2193412-05. indd 4 1/2/08 11:10:02 AM PARTS IDENTIFICATION ON/OFF SWITCH FLEXIBLE HOSE WAND ADJUSTMENT CORD REWIND ELECTRONIC VARIABLE SPEED CONTROL ON/OFF SWITCH DUST INDICATOR LIGHTS ON/OFF SWITCH RESET BUTTON AT REAR OF POWER BRUSH ALL PURPOSE FLOOR HEAD 5 2193412-05. indd 5 1/2/08 11:10:03 AM ACCESSORIES On-board tools are located in their own compartment between control panel and hose outlet and include a crevice tool and turbo brush. Tools simply attach to the end of the wand or the hand piece. 6 2193412-05. indd 6 1/2/08 11:10:03 AM TUR BO B RUSH CREVICE TOOL POWER BRUSH DUST INDICATOR LIGHTS RED INDICATES CARPET IS DIRTY GREEN INDICATES CARPET IS CLEAN TILT ADJUSTMENT ON/OFF SWITCH DUST-SEEKING HEADLIGHT HEIGHT ADJUSTMENT WINDOW CARPET CLEAN INDICATING LIGHTS HEIGHT ADJUSTMENT OVERLOAD RESET BUTTON REAR VIEW The Power Brush is at the centre of the deep cleaning technology. It has a number of innovative features to make cleaning fast and efficient. There is a six step brush height adjustment, a dirt seeking headlight plus you'll know when your carpet is clean when the light turns green. 7 2193412-05. indd 7 1/2/08 11:10:03 AM ASSEMBLING YOUR CLEANER The cleaner should be switched off and disconnected from the mains supply before you start to assemble. 1. Connect the hose body connector to the cleaner making sure it fits firmly. 2. Fit handle into the wand until it clicks into place. 3. Extend or reduce the length of the wand by depressing button and moving the slider. 4. Push the wand into the power brush until it clicks into place. To remove, press button and separate. 5. To use the blower function, remove rear filter cover and filter and fit blower assembly. 6. Insert the hose into the blower outlet until the catches click to engage. 8 1/2/08 11:10:04 AM 2193412-05. indd 8 CHANGING THE GERMASTADT DUST BAG This dust bag has a unique sealing system locking in the dust, making disposal easier, and ensuring no allergens are returned to the room. BAG FULL INDICATOR 1. Change the bag when the bag indicator illuminates. 2. To remove and replace dust bag, open dust bag cover. TAB 3. Lift up dust bag holder and bend tab over to seal bag for disposal. 4. Remove bag by sliding out of bag holder and dispose. TAB 5. [. . . ] It also becomes void if the product is used on an electric voltage other than that shown on the Rating Plate. Ltd is unable to accept responsibility under this guarantee for damage from repair work carried out by other than authorised Service Retailers or Centres, or from the use of other than genuine parts. This guarantee does not apply to the cost of replacing any part of the product due to normal wear and tear, alteration, improper installation, physical abuse, misuse or accident. [. . . ]