User manual VOLTCRAFT BS-100 X V07-10

[. . . ] Be careful not to break the pins inside the plug of the gooseneck camera. After a short time, the image filmed by the camera appears on the screen. Repair works must only be carried out by a specialist/ specialist workshop. ⷠIf you have queries about handling the device, that are not answered in this operating instruction, our technical support is available under the following address and telephone number: Voltcraft®, 92242 Hirschau, Lindenweg 15, Germany, phone 0180 / 586 582 7 So as to be able to use the endoscope even in absolutely dark areas, continuously dimmable LED lighting is integrated in the camera head. [. . . ] Please read the operating instructions thoroughly and keep them for further reference. Disposing used batteries in the household waste is prohibited!Batteries/ rechargeable batteries containing hazardous substances are marked with the crossed-out wheeled bin. You can return used batteries/ rechargeable batteries free of charge to any collecting point of your local authority, our stores or where batteries/ rechargeable batteries are sold. Consequently you comply with your legal obligations and contribute to environmental protection!Use the included AV cable in order to establish the connection to your replay or recording device. The camera image is displayed if the connection and the choice of video source are correct. Parts that have been lost can thus be searched for and retrieved. Carefully plug a compatible gooseneck camera or extension cable into the socket. Be careful not to break the pins inside the plug of the gooseneck camera. If you are using an extension cable, connect a camera to the end of the extension cable. We do not assume liability for resulting damages to property or personal injury if the product has been abused in any way or damaged by improper use or failure to observe these operating instructions. Carefully read the whole operating instructions before operating the device, otherwise there is risk of danger. You should not replace the battery with any other battery. the battery should only be removed or replaced by a specialist / specialist workshop. Remove the battery when the endoscope is not going to be used for a long period of time. Observe the correct polarity when replacing the battery. The battery status icon shows the remaining battery power in five levels. Means the battery is fully charged (higher than 4. When using for the first time or if the battery level is lower than 3. A pop up will window appear to ask if you would like to enter the standby mode. If you select not to enter standby mode, the endoscope enters normal operating mode. [. . . ] If you have a reason to believe that the device can no longer be operated safely, disconnect it immediately and secure it against being operated unintentionally. It can be assumed that safe operation is no longer possible if: - the device is visibly damaged, - the device no longer works and - the unit was stored under unfavourable conditions for a long period of time or - it has been subjected to considerable stress in transit. ⷠYou should also heed the additional safety instructions in each chapter of the operating instructions for the connected devices. ⷠNever switch the device on immediately after it has been taken from a cold into a warm environment. [. . . ]