User manual VOLTCRAFT PL-130 AN

[. . . ] The crossed-out wheeled bin indicates the product needs to be disposed separately and not as municipal waste. Flow velocity can be displayed in five different units on the display and air flow can be displayed in two different units. Effective velocity (average speed), maximum or minimum speed can also be displayed during the measuring process. Power is supplied by three AAA batteries. [. . . ] ⷠDo not switch the product on immediately after it has been taken from a cold to a warm environment. the condensation that forms might destroy the product. Allow the product to reach room temperature before switching it on. Unscrew the screw on the battery compartment cover using a Phillips screwdriver and take off the cover of the battery compartment. Insert three AAA batteries, observing the correct polarity. Take note of the labelling on the inside of the battery compartment. Press the button "UNITS" until the display unit is switched to cubic feet per minute (CFM) or cubic meter per minute (CMM). You need to input the correct cross section area of the gas flow before the The user is legally obliged (battery regulation) to return used batteries and anemometer can give you the correct air flow measurement. press and hold the rechargeable batteries. Disposing used batteries in the household waste button "AREA", after two "beep" sounds, you can input the gas flow area. Substances are marked with the crossed-out wheeled bin. The symbol - Use the button "HOLD" to move to the next digit. Press and hold the button "AREA" to return to the measuring mode, you will hear Cd = Cadmium, Hg = Mercury, Pb = Lead. Two "beep" sounds and the gas flow area is set. The display now shows the air You can return used batteries/ rechargeable batteries free of charge to flow measurement. Any collecting point of your local authority, our stores or where batteries/ rechargeable batteries are sold. ⷠIfoneofthemultipliers(x10orx100)appearsbelowthereading, multiplythe Consequently you comply with your legal obligations and contribute to environmental reading by the multiplier to obtain the correct value. During the measurement process press the button "MAX / MIN" once to display Scan rate: after approx. Press it three Auto switch-off time: Operating temperature: 0 ºC to +50 ºC, < 80 % RH times to display the average value. Press the button "MAX / MIN" four times to Storage temperature: -10 ºC to +60 ºC, < 80 % RH return to normal measuring mode. [. . . ] You will see the word "dis APO" if the auto power off function is deactivated. The auto power off function resumes whenever the anemometer is restarted. Thus, you need to deactivate it if you do not want it. Correct polarity must be observed while inserting the batteries. [. . . ]