User manual VOLTCRAFT VC265 V06-10

[. . . ] Pleasereadthe operating instructions thoroughly and keep them for further reference. Observe all safety instructions and information within this operating manual. An exclamation mark in a triangle indicates important instructions in this operating manual which absolutely have to be observed. The symbol can be found when you are to be given tips and information on operation. [. . . ] Wait until the product adapts to the new ambient temperature before use. ⷠIf there is reason to believe that safe operation is no longer possible, put the device out of operation and secure it against unintended operation. Safe operation is no longer possible if: - the product shows visible damages, - the product no longer works and - the product was stored under unfavourable conditions for a long period of time, - the product was subject to considerable transport stress. ⷠThe manufacturer or supplier accepts no responsibility whatsoever for incorrect displays or the consequences which can arise from such incorrect displays. Batteries must be kept out of the reach of children. ⷠWhen installing the battery, make sure to pay attention to the correct polarity. ⷠDo not let batteries/rechargeable batteries lie around openly. There is a risk of batteries being swallowed by children or pets. Leaking or damaged batteries/rechargeable batteries may cause acid burns when coming into contact with skin, therefore use suitable protective gloves. During storage) remove the inserted battery/accumulator to avoid damage through leaking batteries. The product must not be used for medical or public purposes. If you have selected the "Manual" function, hold down the Data Logger button for two seconds to start the measurement. If you have selected the "Automatic" function, the data logger starts the measurement automatically after you have completed programming the data logger. If you have set a time delay, measurement will commence after the preset time period. duringthemeasurement , thegreenLEDflashesatthefrequencysetinthe"LEDFlashCycle Setup". To stop the measurement manually, hold down the Data Logger button for two seconds. Once the memory of the data logger is full, the measurement is terminated automatically. The recording can also be terminated at any time by displaying the readout on the computer before the recording is complete (see chapter "Displaying data logger readout"). LED signals and their meaning Signal Description flashes once at the frequency set active measurement, readings do not exceed / under "LED Flash Cycle Setup". Under-run the alarm limit values Green (REC) flashes twice at the frequency set with time-delayed start of measurement under "LED Flash Cycle Setup". Flashestwiceevery30seconds reading under-runs alarm lower-limit value flashes three times every 30 reading exceeds alarm upper-limit value Red (ALm) seconds flashesonceevery20seconds weak battery flashesonceevery2seconds temperature sensor not properly connected Red + Green flashesonceevery60seconds memory full --no LED on logger turned off or batteries empty LED You can also click on the icon with the white arrow with blue background. To save the data, choose "File ­ Save" from the menu. [. . . ] todothis , removetheprotectivefilmandpressthewallbracketagainstthe desired surface. The surface must be dry, dust-free and free of grease. The adhesive tape reaches its full adhesive strength for bonding only at temperatures over 5 °C. The device is maintenance-free apart from the need to replace the batteries and cleaning it once in a while. [. . . ]