User manual VOYAGER AOM452

[. . . ] Warning: Backing up vehicle Do not back up vehicle while watching the monitor screen. Always look in the direction of vehicle motion. Use the monitor as an aid in safety confirmation. [. . . ] Do not watch movies while driving. 2. 3. 1 1. Controls and Indicators Figure1 Figure1 illustrates the controls and indicators of the AOM452 Monitor: A: 4. 5" TFT color LCD B: " " button (power button) Switches the unit between Manual mode and Standby mode. When in standby mode the unit will be turned on when either the Camera 1 or Camera 2 trigger is triggered. The unit will turn off when the triggers are released. The unit will turn on if the Power button; Camera button or Map button is pressed. The power button will need to be pressed to turn the unit back off. When in manual mode, the operator can manually switch between Camera 1, Camera 2 and Map mode. Manual mode is activated by pressing the Power button, camera button or Map button. 2 C: "CAM" button: Switches between Camera 1 and Camera 2. Camera 1 ­ Dedicated to the reverse circuit of the vehicle. The mode will override the current video source when the Camera 1 trigger wire is triggered. Camera 2 ­ Dedicated to the turn signal circuit of the vehicle. This mode will handle the turn signal pulse applied when the vehicles turn signals are activated. D: "MAP" button: Activates the Navigation screen and toggles between different map modes for the navigation unit. E: Inside Infra-RED Receiver for Navigation Remote Control. F: " - "Button: Incrementally Decreases the LCD Brightness. [. . . ] Each press of the MAP button will toggle the Navigation unit through a series of mapping screens 2. Press the Power button to turn the unit off. Maintenance Your rearview monitor requires little care, however to maintain it in optimum condition follow the procedures below: 1. Keep your system away from excessive moisture, extreme heat or cold and magnetic fields. [. . . ]