User manual VOYAGER AOM683

[. . . ] Tampering To prevent electrical shock, DO NOT OPEN THE MONITOR CASE. There are potentially harmful voltages inside the monitor. There are no user serviceable parts inside. If evidence of tampering is detected, the warranty will be considered void. [. . . ] In manual mode, the power button is used to turn the unit on/off. In stand-by mode, the unit automatically turns on only when 12V is applied to the stand-by trigger wire. For MANUAL operation, the AOM683 should be wired as follows: The ACC (+12V) lead (red) should be wired to the ACC feed of the vehicle (switched +12V). *Please note that if the unit is in "Stand-by On" mode, the Power Button will appear to have no effect (it will switch from "on" to "on" in this case). For STAND-BY operation, the AOM683 should be wired as follows: The ACC (+12V) lead (red) should be wired to the ACC feed of the vehicle (switched +12V). The stand-by reverse, left, right trigger should be wired to the ACC feed of the vehicle (+12V when the vehicle is in reverse or left signal or right signal). The unit will automatically turn ON whenever the stand-by trigger is +12V with below condition: ­ when Stand-By Reverse trigger is +12v, unit will active AV1 display image on screen. ­ when Stand-By Left trigger is +12V, unit will active AV2 display image on screen. ­ When Stand-By Right trigger is +12V, unit will active AV3 display image on screen. ­ * Note : The unit will not be turn ON during the harzard condition and the three stand-by trigger is in +12V at the same time. 4 The power button features dual-illumination (bright and dim). In installations where the unit is not wired for Stand-by operation and power is applied to the unit, the Power Button will dimly glow when the unit is off, allowing the user to easily find the control in low light. Illumination switches to full intensity when the unit is turned on. S S 2. Source Input Select Button This control toggles the active display image back and forth between AV1, AV2 or AV3 inputs. Day/Night Mode Button This control toggles the unit between "Day" and "Night" LCD illumination modes. In the "Day" mode, the LCD backlight intensity is at maximum. In "Night" mode, the LCD backlight is dimmed to a preset level that is more suitable for low light operation. Picture Adjustment Menu Button This control accesses an On-Screen-Display (OSD) menu for four LCD picture adjustments (Brightness, Contrast, Color, and Tint). The first depress of the button accesses the "Brightness" adjustment. The Volume +/- controls adjust the level, which is indicated by the bar graph at the bottom of the screen. Each consecutive depress of the Picture button accesses the adjustment screen for each picture adjustment. If no buttons are pressed within 6 seconds or controls other than the Picture and Volume buttons are pressed, the unit will exit the Picture Adjustment mode. Volume +/- Buttons This 2-button set of controls adjusts the output volume of the built-in audio speaker when the audio function is enabled *(see typical system connection diagram). The "+" button increases output volume. [. . . ] If the application is such that the monitor is in close proximity to the junction box, the AOM683 monitor can be connected directly to the junction box. If the junction box is mounted further from the monitor, use the 5' intermediate cable included with the AOM683 to connect the monitor to the junction box. If more cable length is needed, additional 5' lengths of the intermediate cable can be purchased. (See the accessory list at the back of this manual for part number details. ) 7. [. . . ]