User manual VOYAGER AOM703

[. . . ] When backing up, proceed cautiously and be prepared to stop. Installation Location It is unlawful in most jurisdictions for a person to drive a motor vehicle equipped with a television viewer or screen located at any point forward of the back of the driver's seat or in any location that is visible, directly or indirectly, to the driver while operating the vehicle. The Voyager product is designed to be used primarily as a rear observation device in conjunction with closed circuit cameras. In any installations where the Voyager is used to display television broadcasts or recorded video playback, installation location must adhere to local laws and regulations. [. . . ] When triggered, the Left Camera image will be displayed on AV2. Standby Camera Trigger 3, Green wire, should be connected to the trigger feed of the Vehicles Right turn signal. When triggered, the Right Camera image will be displayed on AV3. * Note : The unit will not be turn ON when the hazard light are activated. 4 The power button features dual-illumination (bright and dim). In installations where the unit is not wired for Stand-by operation and power is applied to the unit, the Power Button will dimly glow when the unit is off, allowing the user to easily find the control in low light. Illumination switches to full intensity when the unit is turned on. Source Input Select Button This control toggles the active display image back and forth between AV1, AV2 or AV3 inputs. Day/Night Mode Button This control toggles the unit between "Day" and "Night" LCD illumination modes. In the "Day" mode, the LCD backlight intensity is at maximum. In "Night" mode, the LCD backlight is dimmed to a preset level that is more suitable for low light operation. Picture Adjustment Menu Button This control accesses an On-Screen-Display (OSD) menu for four LCD picture adjustments (Brightness, Contrast, Color, and Tint). The first depress of the button accesses the "Brightness" adjustment. The Volume +/- controls adjust the level, which is indicated by the bar graph at the bottom of the screen. Each consecutive depress of the Picture button accesses the adjustment screen for each picture adjustment. If no buttons are pressed within 6 seconds or controls other than the Picture and Volume buttons are pressed, the unit will exit the Picture Adjustment mode. Volume +/- Buttons This 2-button set of controls adjusts the output volume of the built-in audio speaker when the audio function is enabled *(see typical system connection diagram). The "+" button increases output volume. The "-" button decreases output volume. Volume level is indicated by the OSD bar graph at the bottom of the screen. These buttons also serve as adjustment controls while in the Picture Adjustment Menu mode (see above section for details). *Note: The AOM703 requires +12V to be applied to the "Audio Enable" trigger input in order to activate the built-in speaker. If no audio output is heard from the speaker regardless of the volume level adjustment, check this connection. S S ­ + 5 INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN INSTALLATION: Before drilling, be sure that no cable or wiring is on the other side. [. . . ] Connect the 6-pin power harness to vehicle. (See system connection illustration page 8) 8. Plug camera extension cable (available separately) into AV1, AV2 or AV3 input connector on the junction box. Plug observation camera into camera extension cable. [. . . ]