User manual VTECH 3 IN 1 CRUISER

[. . . ] For your child's safety, adult supervision is recommended. This unit should not be used by children weighing more than 50lbs, excessive weight could damage this product. INCLUDED IN THIS PACKAGE One electronic activity panel One walker/ride-on/wagon unit One steering wheel One instruction manual WARNING: All packing materials, such as tape, plastic sheets, wire ties and tags are not part of this toy, and should be discarded for your child's safety. ACTIVITY PANEL OBJECT/SHAPE BUTTONS ON/OFF/MODE SELECTOR SWITCH TRANSMISSION KNOB BATTERY INSTALLATION 1. Locate the battery covers on the back of the activity panel and on the bottom of the main unit. Use a coin or screwdriver to loosen the screws. [. . . ] When the main unit is in the ride-on position, remove the activity panel. 5. To attach the activity panel to the steering wheel, pull the release tabs out and snap the panel into place. Gently pull on the activity panel to ensure it is securely locked. 2. To detach the activity panel, pull the release tabs out and remove the panel. 3. The assembly of the wagon is now complete and ready to be used. 8 © VTECH Printed in China 91-01500-000 9 TO BEGIN PLAY 1. To turn the unit ON, turn the ON/OFF/ MODE SELECTOR SWITCH to the TALKING MODE ( ) position or the MELODY MODE ( ) position. ACTIVITIES A. Turn the ON/OFF/MODE SELECTOR SWITCH to the TALKING MODE ( ) position. You will hear a start-up engine sound effect followed by "Let's go on an adventure!" and a short tune. The lights will flash randomly with the sound. Push the TRANSMISSION KNOB up to hear a revving engine sound effect. The 5 location buttons will light up one by one with the sound. Start-up engine sound effect + "Let's go on an adventure !" Revving sound effect ® 2. To adjust the volume, slide the VOLUME CONTROL SWITCH located on the back of the activity panel to the ( ) position for LOW VOLUME or to the ( ) position for HIGH VOLUME. 3. To turn the unit OFF, turn the ON/OFF/ MODE SELECTOR SWITCH to the OFF ( ) position. 3. Pull the TRANSMISSION KNOB down to hear a beeping sound effect. The 5 location buttons will light up one by one with the sound. Beeping sound effect ® NOTE: To preserve battery life, the VTech® First StepsTM 3-in-1 Cruiser learning toy will automatically power-down after several minutes without input. The unit can be turned on again by pressing any button or by pulling/pushing the unit when the activity panel is attached. Press one of the five LIGHT-UP LOCATION BUTTONS to hear a friendly phrase that identifies the location. The corresponding button will flash randomly with the sound. 11 "Let's go to Grandma's house!" ® 5. Press one of the three OBJECT/ SHAPE BUTTONS to hear the letter and object identified followed by a related sound effect. The lights will flash randomly with the sound. "B is for boat!"+ Boat sound effect ® 9. Press the HORN BUTTON to hear one of three silly horn sound effects. [. . . ] Note: This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer's instructions, it may cause interference to radio and television reception. It has been type tested and found to comply within the limits for a Class B computing device in accordance with the specifications in Sub-part J of Part 15 FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference with radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · · · reorient the receiving antenna relocate this product with respect to the receiver move this product away from the receiver CARE AND MAINTENANCE 1. [. . . ]