User manual VTECH BRIGHT LIGHTS BABY BALL

[. . . ] When it comes to providing electronic learning products that enlighten, entertain and develop minds, at VTech® we see the potential in every child. 1 INTRODUCTION Thank you for purchasing the VTech® LITTLE SMART Bright Lights BabyTM Ball learning toy!We at VTech® are committed to providing the best possible products to entertain and educate your child. Should you have any questions or concerns, please call our Consumer Services Department at 1-800-521-2010 in the U. S. , 1-800-267-7377 in Canada, or (01235) 546810 in the U. K. . The LITTLE SMART Bright Lights BabyTM Ball learning toy is a musical light-up play ball for infants 6 months and up. [. . . ] Interrupt the power supply by removing the batteries. Let the unit stand for a few minutes, then replace the batteries. The unit should now be ready to play again. If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U. S. , 1-800-267-7377 in Canada, or (01235) 546810 in the U. K. , and a service representative will be happy to help you. 4 TO BEGIN PLAY 1. To begin play, slide the ON/OFF MODE SELECTOR SWITCH to either the MUSIC MODE ( MODE ( ) or TALKING ) position. The LITTLE SMART Bright Lights BabyTM Ball learning toy will play a few musical notes. 2. Roll or rotate the ball to hear a funny sound effect followed by a cheerful melody. Star lights will flash along with the sound and music. 4. Slide the ON/OFF/MODE SELECTOR SWITCH to the OFF position ( ) to turn the unit OFF. 5 5. To adjust the volume, slide the VOLUME CONTROL SWITCH located on the bottom of the ball to the ( ) position for LOW VOLUME or to the ( ) position for HIGH VOLUME. Note: Without input after severial minutes the unit will go into a powerdown mode to conserve battery power. The unit can be restarted by pressing any button. ACTIVITIES A. Slide the ON/OFF/MODE SELECTOR SWITCH to the TALKING MODE ( ) position. A short tune will play and star lights will flash along with the sound. 6 2. Press the Mommy or Daddy Character Button to hear a friendly voice say "Hello Baby!" or "Bye-Bye". Star lights will flash along with the voice. 3. Press an Animal Character Button to hear a friendly voice identify the animal followed by a sound effect. Star lights will flash along with the voice. B. Slide the ON/OFF/MODE SELECTOR SWITCH to the MUSIC MODE ( ) position. A short tune will play and star lights will flash along with the sound. 7 2. Press any Character Button to hear a cheerful melody. [. . . ] with any problems and/or suggestions that you might have. A service representative will be happy to help you. Note: This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer's instructions, it may cause interference to radio and television reception. It has been type tested and found to comply within the limits for a Class B computing device in accordance with the specifications in Sub-part J of Part 15 FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. [. . . ]