User manual VTECH CS6219-4

[. . . ] User's manual w w w. v t e c h p h o n e s . c o m Models: CS6219/CS6219-2/ CS6219-3/CS6219-4 Congratulations on purchasing your new VTech product. Before using this telephone, please read the Important safety instructions on page 38 of this manual. This manual has all the feature operations and troubleshooting necessary to install and operate your new VTech telephone. [. . . ] The ringer is muted temporarily during an incoming call. You have attempted to make an intercom call, but the handset you are calling is in the directory, in the call log, out of range or on an outside call. You are attempting to save a caller ID entry with no name or number. There are unreviewed calls in your call log. RINGER MUTE SAVED SPEAKER UNABLE TO CALL TRY AGAIN UNABLE TO SAVE XX MISSED CALLS 28 Appendix Handset and telephone base indicators Handset lights On when the handset speakerphone is in use. CHARGE On when the handset is charging in the telephone base or charger. Telephone base lights IN USE Flashes when there is an incoming call or another telephone sharing the same line is in use. Flashes when you have new voicemail from your telephone company. VOICEMAIL Handset icons MUTE Microphone is muted. NEW NEW VOICEMAIL SPEAKER New call log entries. New voicemail received from the telephone company. Cycles (low, medium, and full) when the handset battery is charging. Flashes when the battery is low and needs charging. Solid when the battery is fully charged. (Battery indicator) 29 Appendix Battery It takes up to 16 hours for the battery to be fully charged. When it is fully charged, you can expect the following performance: Operation While in handset use (talking*) While in speakerphone mode (talking*) While not in use (standby**) Operating time Up to eight hours Up to five hours Up to six days *Operating times vary depending on your actual use and the age of the battery. The battery needs charging when: · · · · A new battery is installed in the handset. A battery is properly installed and the screen is blank. LOW BATTERY or PLACE IN CHARGER shows on the handset screen. CAUTION: To reduce the risk of fire or injury, read and follow these instructions: · Use only the battery(ies) provided or equivalent. To order a replacement, visit our website at www. vtechphones. com or call 1 (800) 595-9511. In Canada, go to www. vtechcanada. com or call 1 (800) 267-7377. · Do not dispose of the battery(ies) in a fire. Check with local waste management codes for special disposal instructions. · Do not open or mutilate the battery(ies). Released electrolyte is corrosive and might cause burns or injury to the eyes or skin. [. . . ] If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer. If this equipment is malfunctioning, it must be unplugged from the modular jack until the problem has been corrected. Repairs to this telephone equipment can only be made by the manufacturer or its authorized agents. For repair procedures, follow the instructions outlined under the Limited Warranty. 43 Appendix FCC, ACTA and IC regulations If this equipment is causing harm to the telephone network, the telephone company may temporarily discontinue your telephone service. [. . . ]