User manual VTECH CS6229

[. . . ] User's manual w w w. v t e c h p h o n e s . c o m Models: CS6228-3/CS6228-6/ CS6229/CS6229-2/ CS6229-3/CS6229-4/ CS6229-5 Congratulations on purchasing your new VTech product. Before using this telephone, please read the Important safety instructions on page 47 of this manual. This manual has all the feature operations and troubleshooting necessary to install and operate your new VTech telephone. [. . . ] · Press 5 to stop. If the answering system has less than five minutes of recording time left, the remaining time is announced. If F and number of messages are flashing in the message window, the memory is full. Delete some messages to make room for more. You can only delete old messages, which are messages you have played. 31 Answering system operation Delete all messages To delete all messages with the telephone base: Press X/DELETE when the phone is not in use. The telephone announces, "To delete all old messages, press DELETE again. " Press X/DELETE again. All previously heard messages are erased and the telephone announces, "All old messages deleted. " To delete all messages with a handset: 1. Press MENU/SELECT to show the menu when the handset is not in use. Press or to select >DEL ALL OLD, then press MENU/SELECT. Press MENU/SELECT to confirm your selection. Record and play memos Memos are your own recorded messages used as reminders for yourself or others using the same answering system. You can record your own memos using a system handset. Playback and delete them in the same way as incoming messages. Record a memo Press MENU/SELECT to show the menu when the handset is not in use. Press or to select >RECORD MEMO, then press MENU/SELECT. The handset announces, "Record after the tone. Press 5 when you are done. " After the tone, speak towards the microphone of the handset. The handset announces, "Recorded. " 1. 4. "Memory is full, " is announced if you record a memo when the memory is full. Each memo can be up to four minutes in length. Memos shorter than one second are not recorded. 32 Answering system operation Message window displays Window displays 0 1-99 0-99 (flashing) 1-99 & F (alternating) 1-99 (flashing) 1-99 1-8 --- (flashing) 0-6 Descriptions No messages. The telephone base might have lost and regained power. Memory is full with total number of messages recorded. Current message number during new message playback. Current message number during old message playback. [. . . ] If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer. If this equipment is malfunctioning, it must be unplugged from the modular jack until the problem has been corrected. Repairs to this telephone equipment can only be made by the manufacturer or its authorized agents. For repair procedures, follow the instructions outlined under the Limited Warranty. 52 Appendix FCC, ACTA and IC regulations If this equipment is causing harm to the telephone network, the telephone company may temporarily discontinue your telephone service. [. . . ]