User manual VTECH I6727

[. . . ] User's manual www. vtechphones. com Model: i6727 Important!Before using this telephone, please read the Important safety instructions on page 35 of this manual. NEED HELP? This manual has all the feature operations and troubleshooting you need to install and operate your new VTech telephone. Please take the time to review thoroughly to ensure proper installation of this VTech innovative and feature rich product. You can also visit our website at www. vtechphones. com for support, shopping, and everything new at VTech. [. . . ] If this telephone does not work, the problem is probably in the wiring or the local service. · Place the handset in the telephone base or charger for recharging. · Remove and re-install the battery and use it normally until fully discharged, then recharge the handset on the telephone base or charger for 16 hours. · If the above measures do not correct the problem, the battery may need to be replaced. Low Battery is displayed on screen. 28 www. vtechphones. com Troubleshooting Problem Suggestion The battery does not · Make sure the handset is placed in the charger correctly. The CHARGE light on the telephone charge in the handset base or charger should be on. or the handset battery · Remove the battery from the handset and install it in the spare battery compartment on the does not accept charge. side of the telephone base and let it charge for 16 hours. Then re-install the charged battery into the handset. · If the cordless handset is in the charger or in the telephone base but the CHARGE light is not on, refer to The charge light is off in this section. · It may be necessary to purchase a new battery. Please refer to the Battery section (see page 27) of this user's manual. · The telephone might be malfunctioning. Please refer to the Warranty section (see page 37) of this user's manual for further instruction. · Clean the charging contacts on the cordless handset(s) and telephone base each month using a pencil eraser or a dry non-abrasive fabric. · Make sure the power adapter and telephone line cords are plugged in correctly and securely. Wait for 15 seconds before plugging it back in. Allow up to one minute for the cordless handset and telephone base to reset. · The telephone might be malfunctioning. Please refer to the Warranty section (see page 37) of this user's manual for further instruction. Appendix www. vtechphones. com 29 Troubleshooting Problem Suggestion The CHARGE Indicator · This is a signal that the battery is very low, completely depleted, or when there is no electrical on the telephone base contact between the battery and the telephone base. · Ensure the connector of the battery is securely plugged into the handset and place the handset in the telephone base for charging. · · · · First, try all the above suggestions. Move the cordless handset closer to the telephone base. [. . . ] You will be given the opportunity to correct the problem and the telephone company is required to inform you of your right to file a complaint with the FCC. Your telephone company may make changes in its facilities, equipment, operation, or procedures that could affect the proper functioning of this product. The telephone company is required to notify you if such changes are planned. If this product is equipped with a corded or cordless handset, it is hearing aid compatible. [. . . ]