User manual VTECH T 2406

[. . . ] Important Safety Instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury, including the following: 1. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. [. . . ] To redial the last number you called, press PHONE then press REDIAL/ PAUSE. In Canada, call VTech Electronics at 1-800267-7377. The Phone Doesn't Work At All · · · Make sure the Power Cord is plugged in. Make sure the telephone line cord is plugged firmly into the Base Unit and the telephone wall jack. Make sure the batteries are properly charged. If the LOW BATT LED is slowly flashing, the battery pack needs charging. If you still don't hear a dial tone, disconnect the Base Unit from the telephone jack and connect a different phone. If there is no dial tone on that phone either, the problem is in your wiring or local service. Contact your local telephone company. No Dial Tone · · You Get Noise, Static, Or A Weak Signal Even When You're Near The Base Unit · Household appliances plugged into the same circuit as the Base Unit can sometimes cause interference. Try moving the appliance or the Base Unit to another outlet. You Get Noise, Static, Or A Weak Signal When You're Away From The Base Unit · · You may be out of range. Either move closer to the Base, or relocate the Base Unit. The layout of your home may be limiting the range. Try moving the Base Unit to another position. Make sure you have the Handset ringer activated. To set the ringer, see Programming the Ringer Type. Make sure the telephone line cord is plugged firmly into the Base Unit and the telephone jack. You may have too many extension phones on your telephone line to allow all of them to ring. Try unplugging some of the other phones. Disconnect your Base Unit from the telephone jack, and plug in a regular telephone. If you still hear other calls, the problem is probably in your wiring or local service. Make sure the power cord is plugged in. The Handset Does Not Ring When You Receive A Call · · · · You Hear Other Calls While Using Your Phone · You Hear Noise In The Handset, And None Of The Keys Or Buttons Work · 13 In Case Of Difficulty Common Cure For Electronic Equipment If the unit does not seem to be responding normally, then try putting the Handset in the cradle. If it does not seem to respond, do the following(in the order listed) : 1. Re-install the battery pack, and return the Handset to the charge cradle. [. . . ] The abbreviation, IC, before the registration number signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It does not imply that Industry Canada approved the equipment. " "NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is 0. 1. The REN assigned to each terminal equipment provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed five. '' 20 FCC, ACTA and IC Regulations Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. [. . . ]