User manual VTECH V 30-9116

[. . . ] EASY ONE - TOUCH ACCESS TO dialpadSM SERVICE - NO PC OR ISP REQUIRED 900MHz HIGH FREQUENCY INTRODUCTION 30-9116 dialpadSM SERVICE Parts Check List: 1. Belt Clip USERS MANUAL HANDSET BASE UNIT TELEPHONE LINE CORD BATTERY PACK AC ADAPTER VTECH To help protect the environment, this product may contain recycled or reconditioned parts and materials. MHz VTECH TELECOMMUNICATIONS LTD Printed in China 91-5182-10-00 ISSUED 0 WALL MOUNTING BRACKET BELT CLIP 1 IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. [. . . ] * It can also be used to store the last number dialed into the speed dial memory. See Storing a Redial Number into Speed Dial for details. TONE/ KEY * In PULSE dialing mode, this key is used to switch to Temporary TONE dialing mode. VOLUME SWITCH * There are three volume settings: Low, Medium and High. BATTERY LOW WARNING BEEP * Upon pressing PHONE, the Handset will emit two beeps to indicate that the battery pack needs to be recharged. OPERATING INSTRUCTIONS Making Calls Pick up the Handset and press PHONE. When you hear a dial tone, dial the number. The PHONE LED will illuminate while the Handset is in use. If you make a mistake when dialing, press PHONE KEY to hang up, then press PHONE to get the dial tone again. You must always press PHONE before you can dial a call on the handset. Making a dialpadSM Call Press PHONE KEY, dialpadSM key on the cordless handset to access your internet telephone account. Follow the voice prompts to complete your call. Handset Ringer Style You can select from four different handset ringer styles. 1. Press 1, 2, 3 or 4 to select your ringer style. You will hear a sample of the ringer style. To turn the ringer on again, see Handset Ringer Style. OPERATING INSTRUCTIONS Changing your dialpadSM Contact Number This phone is pre-programmed to dial 1-800DIALPAD when you press dialpadSM key. If you have a local POP (Point of Presence) number for dialpadSM, you need to reprogram this contact number. 1. Press PROG/MEM KEY, The PHONE light NOTE: Your VT30-9116 is preset at the factory for TONE dialing. Temporary Tone If you have a rotary (dail-pulse) telephone service, (TONE/PULSE setting is set to PULSE), this feature allows you to enter special codes and tones to operate answering machines, use electronic banking services, calling cards, or other special services. Then activate the Temporary Tone feature by pressing TONE(the * key). You can then press the numbers or symbols you need, and your phone will send the proper signals. To end the call, press PHONE or place the handset ack in the base. The phone will automatically go back to rotary (dialpulse) service. [. . . ] You may also have other rights which vary from state to state. IF YOU PURCHASED YOUR TELEPHONE IN CANADA Please call: 1-800-267-7377 Ship to: VTECH ELECTRONICS 200-7671 ALDERBRIDGE WAY RICHMOND, BC V6X 1Z9 12 13 FCC REGULATIONS FCC AND IC REGULATIONS This equipment complies with Parts 15 and 68 of the Federal Communications Commission (FCC) rules for the United States. It also complies with regulations RSS-210 and CS03 of Industry Canada (IC). A label is located on the underside of the base unit containing either the FCC registration number and Ringer Equivalence Number (REN) or the IC registration number and Load Number. [. . . ]