User manual VTECH VT 2461

[. . . ] Important Safety Instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. 10. 11. Read and understand all instructions. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. [. . . ] Then OGM replays the message automatically, followed by a beep. To review a recorded announcement, press MENU key until "Set Outgoing Message" is announced. To delete a recorded announcement, press ERASE during OGM playback. You then hear "Outgoing Message has been erased". NOTE: If your recording time is less than 2 seconds, your OGM will not be recorded, and the default greeting will be used. Set Security Code 1. 3. 4. Press MENU unit you hear "Set security code. " Press TIME/SET to hear the current security code. Press SELECT briefly to increase the security code by 1. Or, hold SELECT continuously to increase the code by multiples of 10. Press TIME/SET to confirm your choice and you will hear the announcement of the security code. 31 Itad Operation The security code programmed into the Answering System is used to gain access to functions from remote locations. The security code default setting is 19 . You can select any two-digit code, from 00 to 99. Answering System Setup Day and Time During initial setup, or after a power failure, the day and time default is set to Monday, 12:00am. The display will flash "CL" to indicate day and time need to be set. 1. 6. 7. Set Audible Message Alert Press MENU unit you hear, "Set day and time. " Press SELECT until the correct day is announced. Press SELECT until the correct hour is announced. Press SELECT until the correct minute is announced. Holding the key continuously will increase the minutes by 10 minute steps. You will hear an announcement of the day and time. Itad Operation If you want your Answering System to beep once every 10 seconds to notify you when new messages have been received, set Audible Message Alert to ON. 3. Press MENU until you hear "Set Audible Message Alert. " Press SELECT until the desired setting, (ON or OFF) is announced. The voice prompt of "Audible Message Alert On" or "Audible Message Alert Off" will be heard. 32 Answering System Setup Set Announce Only CAUTION: If you turn on the Announce Only option, your callers cannot leave a message. 1. 3. Press MENU until "Set Announce Only" is announced. Press SELECT until desired setting "ON" or "OFF" is declared. Press TIME/SET to confirm, and the setting will be announced. Note: You can store one OGM for Announce Only mode, and a separate OGM for Normal (accept messages) mode. [. . . ] This equipment may not be used on coin service provided by the phone company or Party Lines. The REN is useful in determining the number of devices you may connect to your telephone line and still enable the devices to ring when you receive a call. The general rule is that the REN value should not exceed 5. 0A total; however, contact your local telephone company for the specific number in your area. IC (Industry Canada) This telephone is registered for use in Canada. Notice : The REN assigned to this device denotes the number of devices you may connect to the telephone loop which is used by the device to prevent overloading The termination on a loop may consist of any combination of devices subjected only to the requirement that the sum of the REN does not exceed five (5. 0) 49 Additional Information Notice : The Industry Canada label identifies certified equipment. [. . . ]