User manual VTECH VT 2651

[. . . ] Important Safety Instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury, including the following: 1. 6. Read and understand all instructions. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. [. . . ] -ORPlace the Handset in the Base cradle to end your call. Answering Calls From the Handset · · Advanced Operations Making Calls · Press any key except OFF or the soft keys. If you press OFF when the Handset is ringing, the ringer will be temporarily muted. -ORPlace the Handset in the Base cradle to end your call. From the Base Unit SPEAKERPHONE · · Press SPEAKERPHONE. Press SPEAKERPHONE to end your call Answering Calls From the Base Unit SPEAKERPHONE · · Press SPEAKERPHONE. Press SPEAKERPHONE to end your call. REDIAL Redial from Base Unit · Pressing REDIAL will immediately dial the last number in the base unit redial memory. Hold down the REDIAL key for more than 2 seconds to erase the contents in redial memory. This is to prevent the accidental dialing of the number stored in redial memory. You will hear a confirmation tone. 24 Handset and Base Operation Mute Function MUTE During an active call pressing either the MUTE soft key on the Handset or the MUTE key on the Base ( when in speakerphone mode ), will disable the microphone. Press MUTE key again to return to normal 2-way conversation. Hold Function During an active call using the Handset, press the HOLD soft key to place your call on hold. Press ON (or SPEAKER) to return to the twoway conversation. Flash Function FLASH You can use your v 2651 with services such as Call Waiting. Simply press the ON key on the Handset to flash the line. Using the Base Speakerphone, press the FLASH key. VOLUME 1 From the Handset: During an active call, press the VOL soft key, then use the adjust the earpiece (or Handset Speaker) volume. and soft keys to Notice the change in the display graph as you adjust the volume. An increase in volume will be represented by an increase in shaded area on the graph. A decrease in volume will result in a reduction of the shaded area. Press OK to confirm your setting. From the Base: During an active call, press the VOLUME keys to adjust the speakerphone volume. You will hear a special tone when you reach the highest or lowest setting. 25 Advanced Operations Volume Control Handset and Base Operation INTERCOM INTERCOM From Base to ALL Handsets: · To page all Handset from the Base press the INTERCOM key. This will cause all Handsets linked with this Base to ring. Each Handset will display GLOBAL CALL FROM BASE. Any Handset can then answer the PAGE, and enter INTERCOM mode with the Base by pressing the INTERCOM key. To end an intercom call, press OFF on the Handset or INTERCOM on the Base. · · · From Base to a particular Handset : · · · Advanced Operations Press the Base INTERCOM key, then press the number of the Handset you want to call (e. g. Handset 2 can then answer the intercom call by pressing INTERCOM key. [. . . ] The REN assigned to each terminal equipment provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed five. Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. [. . . ]