User manual VTECH VT 5825

[. . . ] Important Safety Instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury, including the following: 1. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. [. . . ] · Press ON or SPEAKER key to dial the number. 19 Basic Operation Calls Log (Caller ID - Call Waiting) Deleting Caller ID · Follow the steps in Reviewing Caller ID to scroll to the record to be deleted. · Press DELETE key to delete the desired record. A confirm tone will sound and the previous Caller ID record will be displayed on the screen. · To delete all the Caller ID records, press and hold the DELETE key. The screen will ask you DELETE ALL CALLS?Or, press OFF to return to the CID record previously displayed. Basic Operation 20 Handset Settings Ringer Volume · From the idle (OFF) mode, press SEL then or key to RINGER VOLUME. The current ringer volume will be shown: · Press and keys or enter digit 0-6 to the desired ringer volume. The current ring tone is played and the volume bar is increased/decreased each time the setting is adjusted. At the lowest setting, display will show: · The Handset will not ring when a call comes in if Ringer Volume is setted to the lowest setting. · Press SEL to confirm the setting. Ringer Tone · From the idle (OFF) mode, press SEL then or key to RINGER TONE. You will then be prompted to choose INTERCOM CALL or OUTSIDE CALL. Press or keys to select the desired option. You can then use keys or enter digit 0-9 to sample the ring tones. The screen, will show: · Press SEL to confirm your setting. Key Tone (preset to ON) · From the idle (OFF) mode, press SEL then or key to KEY TONE. The current setting will be or keys to scroll to ON or shown. When set to ON, the Handset will emit a beep whenever a key is pressed. · When the desired option is shown, press SEL to confirm your selection. 21 Basic Operation Handset Settings Handset Name (preset as `VTECH') · It is possible to give each Handset its own unique name. The name is shown in the first line when the Handset is idle. The name can be a maximum of 16 characters in length. Basic Operation · From the idle (OFF) mode, press SEL then or key to HANDSET NAME. · Press SEL again. The display will show the current setting, for example: · Press DEL to backspace then `spell' the desired name. NOTE: The characters are entered in the same way as for the phone book, see the table in page 15. [. . . ] This feature is provided only as a convenience, and the manufacturer assumes no responsibility for customer reliance upon the memory feature. Testing the emergency telephone numbers you have stored is not recommended. However, if you do make a call to an emergency number: · You must remain on the line and briefly explain the reason for the call before hanging up. · Programming/testing of emergency numbers should be performed during offpeak hours, such as in the early morning or late evening, when the emergency services tend to be less busy. [. . . ]