User manual VTECH VT1712

[. . . ] Earpiece Covers To purchase replacement battery packs, call VTECH Communications at 1-800-5959511. In Canada, call VTECH Electronics at 1-800-267-7377. 1 VTECH COMMUNICATIONS Made in China 91-5087-10-00 FCC AND IC REGULATIONS This equipment complies with Parts 15 and 68 of the Federal Communications Commission (FCC) rules for the United States. It also complies with regulations RSS210 and CS-03 of Industry Canada (IC). A label is located on the underside of the base unit containing both the FCC registration number and Ringer Equivalence Number (REN) or the IC registration number and Load Number. [. . . ] flash You can use your VTech VT1712 cordless phone with services such as Call Waiting. REDIAL To redial the last number you dialed, press PHONE, then press REDIAL. The phone will automatically dial the number. HOLD Press HOLD to place an active call on hold. The PHONE LED will flash to indicate the call is on hold. Press PHONE or HOLD again to return to the call. If a call is on Hold using VT1712 and the user picks up another phone on the same link, the VT1712 will take itself off hold and turn off. therefore, you do not have to go back to turn the phone off if you go to another extension. To cancel the page, either press PAGE on the base, or press OFF on the handset. ADVANCED FUNCTIONS TEMPORARY TONE If you have rotary (dial-pulse) telephone service (TONE/PULSE switch is set to PULSE), this feature allows you to temporarily switch to TONE dialing for such purposes as remote access to answering machines, bank-by-phone services, use of calling cards and other special services. Then activate the Temporar y Tone feature by pressing (TONE key). You can then press the numbers or symbols you need, and your phone will send the proper tones. 3 for ringer type 3 4 for ringer type 4 BASIC OPERATION you wish to delete (01. . 20). * The phone will emit two short beeps and exit programming mode. NOTE:Stored numbers are retained in memory even if the base loses its power or the handset battery is removed. STORING SPECIAL CODES To insert a pause in a phone number, press REDIAL/PAUSE at the appropriate point when entering the number. For longer pauses, press REDIAL/PAUSE two or more times. Each press makes the pause 2 seconds longer, and is treated as a stored digit. If your phone is connected to a PBX you can store the PBX access number and a pause before the phone number. For example, to store 9-PAUSE-555-1234 in memory location 08, do the following: * The handset must be OFF * Press MEM/PROG * Press 9 * Press PAUSE/REDIAL, to insert a two second pause * Dial 5551234 * Press MEM/PROG * Press 08 (memory location) * If programmed correctly, the phone will emit two short beeps and exit programming mode. OUT OF RANGE WHEN PHONE IS ON If you are presently engaged in a phone conversation move closer to the base. If the base unit does not communicate with the handset within 25 seconds of losing contact, it will automatically hang up. * A confirmation ring will be heard for the new ringer type. [. . . ] * Include in the package a copy of the sales receipt or other evidence of date or original purchase (if the unit was purchased within the last twelve months). * Print your name and address, along with a description of the defect, and include this in the package. * Include payment for any service or repair not covered by warranty, as determined by VTECH Communications. * Ship the unit via UPS Insured, or equivalent to: VTECH COMMUNICATIONS 11035 SW 11th STREET BLDG. [. . . ]