User manual VTECH VT2431

[. . . ] Important Safety Instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. 11. Read and understand all instructions. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. [. . . ] To exit without saving press . *** Basic Operation · · * Select Tone / Pulse: · · · · · The phone must be off. The Base will emit a happy tone and the Power and Line In Use LEDs will flash rapidly. Press the 7 key to toggle between TONE and PULSE dialing mode. The Line In Use LED will toggle ON when TONE is selected and OFF when PULSE is selected. To save the TONE/PULSE selection (and exit) press # . To exit without saving press . *** * Select Base Ringer Volume and OFF: · · · · · · The phone must be off. The Base will emit a happy tone and the Power and Line In Use LEDs will flash rapidly. Press the volume up and down keys ( / ) to adjust the Base Ringer volume. After each press of the volume keys, the Base will emit the selected Ringer and volume setting for one second. To turn the Base ringer OFF, press the volume down key ( ) until no ringer preview is played. To save the Ringer Volume selection (and exit) press # . To exit without saving press . *** * 24 Handset and Base Operation Making Calls From the Handset · Press ON (or, HANDSFREE to use the Handset Speakerphone feature). Dial the phone number. -OR· · Dial the phone number first; then press ON (or HANDSFREE). Press OFF to end your call. Answering Calls From the Handset · · Press any key except OFF or the softkey. Press OFF to end your call. Making Calls From the Base Unit · · Press SPEAKERPHONE. Press SPEAKERPHONE to end your call. Answering Calls From the Base Unit Redial from Base Unit · · Press SPEAKERPHONE. Press SPEAKERPHONE to end your call. · · Pressing REDIAL will immediately dial the last number in the base unit redial memory. Hold down the REDIAL key for more than 2 seconds to erase the contents in redial memory. This is to prevent the accidental dialing of the number stored in redial memory. 25 Advanced Operations Handset and Base Operation Mute Function During an active call pressing either the MUTE soft key on the Handset or the MUTE key on the Base (when in speakerphone mode), will disable the microphone. Press MUTE key again to return to normal 2-way conversation. Hold Function From the Handset : · Press the HOLD soft key to place a call on hold. To return to the call press the ON or HANDSFREE key. From the Base : · During an active call, press the HOLD key to place a call on hold. [. . . ] Notice : The REN assigned to this device denotes the number of devices you may connect to the telephone loop which is used by the device to prevent overloading The termination on a loop may consist of any combination of devices subjected only to the requirement that the sum of the REN does not exceed five (5. 0) Notice : The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operational and safety requirements. The Department does not guarantee the equipment will operate to the user's satisfaction. Additional Information 38 FCC and IC Regulations Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. [. . . ]