User manual VTECH VT9011

[. . . ] Handset Base Unit Telephone line cord Battery Pack AC Adapter To purchase replacement battery packs, call VTECH Communications at 1-800-595-9511. In Canada, call VTECH Electronics at 1-800-2677377. HANDSET BASE UNIT TELEPHONE CORD BATTERY PACK AC ADAPTER 1 IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury, including the following: 1. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. [. . . ] If you still have difficulty after trying these suggestions, In the US Call: VTECH Communications at 1-800-595-9511. In Canada Call: VTECH Electronics at 1-800-267-7377. · Make sure the power cord is plugged in. · Make sure the telephone line cord is plugged firmly into the Base Unit and the telephone wall jack. · Make sure the batteries are properly charged. If the Handset makes two beeps, the batteries need charging. If the IN USE indicators do not light when you press ON, you must charge the batteries. · If you recently installed a new battery pack, make sure it is installed correctly. · First check all the suggestions above. · If you still don't hear a dial tone, disconnect the Base Unit from the telephone jack and connect a different phone. If there is no dial tone on that phone either, the problem is in your wiring or local service. YOU GET NOISE, STATIC, OR A WEAK SIGNAL EVEN WHEN YOU'RE NEAR THE BASE UNIT. Household appliances plugged into the same circuit as the Base Unit can sometimes cause interference. Try moving the appliance or the Base Unit to another outlet. YOU GET NOISE, STATIC, OR A WEAK SIGNAL WHEN YOU'RE AWAY FROM THE BASE UNIT. Either move closer to the Base, or relocate the Base Unit. · The layout of your home may be limiting the range. Try moving the Base Unit to the second or third floor, or to some other location. THE HANDSET DOES NOT RING WHEN YOU RECEIVE A CALL. · Ensure that the ringer is turned on. · Make sure the telephone line cord is plugged firmly into the Base Unit and the telephone jack. · You may be too far from the Base Unit. [. . . ] Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment. Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas. Caution : Users should not attempt to make such connections themselves, but should contact the appropriate electrical inspection authority, or electrician, as appropriate. [. . . ]