User manual VTECH VT9108

[. . . ] INTRODUCTION USERS MANUAL VTECH VT 9108/9105 900MHz CORDLESS TELEPHONE Parts Check List: 1. Wall mounting bracket HANDSET BASE UNIT TELEPHONE LINE CORD AC ADAPTER VTECH COMMUNICATIONS LTD. Print in China 91-5050-10-00 ISSUE 0 BEFORE USING YOUR NEW PHONE, WE STRONGLY RECOMMEND YOU READ THIS MANUAL THOROUGHLY. IMPORTANT BATTERY PACK WALL MOUNT BRACKET 1 IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Follow all warnings and instructions marked on the product. [. . . ] When you hear a dial tone, dial the number. The indicator for IN USE (on the handset) will light. If you make a mistake when dialing, press OFF to hang up, then press PHONE to get the dial tone again. You must always press PHONE before you can dial a call on the handset. Answering Calls When an incoming call is ringing, the IN USE LED on the handset will flash. To make sure your phone rings when the handset is away from the base, please keep the base antenna in the upright position. To answer a call when the handset is in the base, just pick up the handset. To answer a call when the handset is away from the base, just press any key on the handset (except OFF). This is very useful in a dark environment; you do not have to fumble around looking for the PHONE key to answer the call. OPERATING INSTRUCTIONS Disconnecting To end a call, either place the handset back in the base, or press OFF on the handset. Changing Channels If you notice interference when using your handset, press CHAN to switch to a clear channel. This function is only available when you are on a call. Temporary Tone If you have a rotary (dial-pulse) telephone service, (TONE/PULSE switch is set to PULSE), this feature allows you to enter special codes and tones to operate answering machines, use electronic banking services, calling cards, or other special services. Then activate the Temporary Tone feature by pressing TONE (the key). You can then press the numbers or symbols you need, and your phone will send the proper signals. To end the call, press OFF or place the handset back in the base. The phone will automatically go back to rotary (dial-pulse) service. Programming The Ringer Type The handset ringer is capable of four different types of ringing tones. For longer pauses, press and hold the key until it beeps three or four times. Each additional beep indicates an additional 2 second pause. If your phone is connected to a PBX you can store the PBX access number and a pause before the phone number. For example, to store 9PAUSE-555-1234 in memory location 8 do the following: 1. Press and hold 9 until it beeps at least twice. [. . . ] * Connect the equipment into an outlet or on a circuit different from that to which the receiver is connected. * Consult the dealer or an experienced radio/ TV technician for help. FCC Part 68 The FCC requires that you connect your cordless telephone to the nationwide telephone network through a modular telephone jack (USOC RJ11C or RJ11W). Your telephone company may discontinue your service if your equipment causes harm to the telephone network. [. . . ]