User manual VTECH VT9116

[. . . ] HEADSET CAPABLE (2. 5mm) 900MHz HIGH FREQUENCY INTRODUCTION USERS MANUAL Parts Check List: 1. Belt Clip CHARGING PAGE HANDSET BASE UNIT TELEPHONE LINE CORD BATTERY PACK AC ADAPTER VTECH To help protect the environment, this product may contain recycled or reconditioned parts and materials. MHz VTECH TELECOMMUNICATIONS LTD Printed in China 91-5141-11-00 ISSUED 0 WALL MOUNTING BRACKET BELT CLIP 1 IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. [. . . ] Answering Calls When an incoming call is ringing, the PHONE LED on the handset will flash. To make sure your phone rings when the handset is away from the base, please keep the base antenna in the upright position. To answer a call when the handset is in the base, just pick up the handset. To answer a call when the handset is away from the base, just press any key on the handset (except OFF). This is very useful in a dark environment; you do not have to fumble around looking for the PHONE key to answer the call. Disconnecting To end a call, either place the handset back in the base, or press OFF on the handset. Changing Channels If you notice interference when using your handset, press CHAN to switch to a clear channel. This function is only available when you are on a call. OPERATING INSTRUCTIONS TONE/PULSE Setting If you have touch tone service on phone line, Press PROG, *, *, MEM to switch to TONE dialing. If you have rotary service, press PROG, *, #, MEM to switch to PULSE dialing. NOTE: Your VT 9116 is preset at the factory for TONE dialing. Temporary Tone If you have a rotary (dial-pulse) telephone service, (TONE/PULSE setting is set to PULSE), this feature allows you to enter special codes and tones to operate answering machines, use electronic banking services, calling cards, or other special services. Then activate the Temporary Tone feature by pressing TONE (the key). You can then press the numbers or symbols you need, and your phone will send the proper signals. To end the call, press OFF or place the handset back in the base. The phone will automatically go back to rotary (dial-pulse) service. Programming The Ringer Type The handset ringer is capable of four different types of ringing tones. The following sections detail how to change the different tones and to turn off a ringer on the handset. For longer pauses, press REDIAL/ PAUSE two or more times. Each press makes the pause 2 seconds longer and is treated as a stored digit. If your phone is connected to a PBX you can store the PBX access number and a pause before the phone number. For example, to store 9-PAUSE-555-1234 in memory location 8 do the following: 1. Press MEM Using REDIAL To REDIAL the last number you called, press PHONE then press REDIAL. [. . . ] * Connect the equipment into an outlet or on a circuit different from that to which the receiver is connected. * Consult the dealer or an experienced radio/ TV technician for help. FCC Part 68 The FCC requires that you connect your cordless telephone to the nationwide telephone network through a modular telephone jack (USOC RJ11C or RJ11W). Your telephone company may discontinue your service if your equipment causes harm to the telephone network. [. . . ]