User manual WACOM PENPARTNER

[. . . ] Watch for the Penabled logo to ensure you are getting the natural feel and superior p e r f o r m a n c e o f Wa c o m ' s p a t e n t e d cordless and battery-free pen technology. 3 If you have trouble installing the PenParner Driver software. Getting Started with PenPartner the WACOM Tablet Driver CD contains the installation software and the Readme file. Some configurations may also contain some additional application software. [. . . ] â· Connect the tablet into a different USB port or try connecting to the USB port on another computer. â· If the tablets status LED does not illuminate after your computer is on and has finished booting up, your USB port may be disabled. Move your pen across the active area of the tablet; the screen cursor should move in the corresponding direction on your monitor. press the pen tip against the tablet surface. The status LED on the tablet should turn from orange to green. Now, without applying pressure to the pen tip, hold the pen tip within 5 mm (0. 2 inch) of the tablet surface and press the side switch. The status LED should again change from orange to green. If not, you may have a defective pen or tablet. If you encounter problems with your tool(s) or tablet, refer to the following tables. Your problem may be described here, and you can try the solution offered. The computer does not Check if there is an available USB port on a USB have an available USB port. If none are available you will need to add a USB hub. If you are connecting to a USB hub device, make sure the hub is connected to an active USB port and that the hub is active. The tablet driver software was not installed or did The pen works only in not load properly. Mouse mode, and does Make sure the tablet driver software is installed not draw with pressureand functioning. Select the CLICK SOUND option (the check box should be checked) so that you can hear when the pen registers a mouse click. Note that your computer speakers must be turned on and the volume audible before you can hear CLICK SOUND. Be sure you are quickly tapping the tablet twice in the same place on the tablets active area. Try setting your system to launch programs with a single click. You notice a screen delay In the Tablet control panel, try decreasing the DOUBLE-CLICK DISTANCE. You have to press hard with Open the Tablet control panel. [. . . ] If your video display areas do not form a rectangle because they are different sizes or they are not evenly aligned, the screen cursor positioning will be incorrect after moving into the unmapped area of the virtual desktop. To reestablish the correct screen cursor position, lift your tool out of tablet proximity and bring it back into proximity over an area of the tablet that is mapped to a display area. Reboot the system after installing the tablet on a system with multiple users. After installing the tablet on a system with multiple users, the tablet only works on the primary user desktop. [. . . ]