User manual WAGNER W20

[. . . ] NOTE: These steps can be followed when using oilbased and latex paints. Pull plunger back to draw remaining paint from roller arm into tube. Press fill valve of main tube onto fill tube. Push plunger forward to return excess paint to can. [. . . ] Push plunger forward to return excess paint to can. Move switch to APPLY, then squeeze the trigger on the main tube. Press locking tab and remove roller cover assembly from arm. Insert thumb to first knuckle, PRY and PULL the cap from the roller cover. Once the cap is removed, PUSH the roller cover out the other end. NOTE: When using either method, do not oversaturate the roller. Because priming the roller may use a lot of the paint in the main tube, you may need to refill the main tube after priming. Once paint appears through the roller cover, begin rolling. keep paint flowing to the roller by squeezing the trigger as necessary. Refill as necessary to complete project. NOTE: When putting the plunger back into the main tube, make sure the O-rings do not twist or cut. There is paint leakage on the roller arm assembly The seal on the arm is backwards The seal and cap were not properly cleaned The O-ring and the connecting area were not cleaned properly Paint residue on connecting areas The O-rings are damaged or missing The roller cover is worn or damaged The core or cap is worn or damaged The bearing areas are worn Turn the seal around Clean and properly lubricate Clean and properly lubricate Clean connecting areas Replace the O-rings* Replace the roller cover* Replace the core or cap* Call Customer Service Lubricate the O-rings on the plunger A) Insert fill tube firmly into fill valve and twist fill tube several times to break up paint residue B) If the problem persists, refer to the steps below to clean the fill valve components Plunger is difficult to pull/push The fill tube will not fill with paint or paint leaks from fill valve O-rings are not lubricated Paint residue on fill valve components Clean these parts thoroughly using the appropriate cleaning solution. Screw the locking cap on the valve housing by turning it clockwise. * Replacement parts available by calling customer service Have you tried the recommendations above and are still having problems?In the United States, to speak to a customer service representative, call our Customer Service at 1-763-519-3555 Monday through Friday between 8:00 AM and 4:30 PM Central time. An automated Self-Help option is also available at 1-800-328-8251, seven days a week, twenty-four hours a day. Send in your product registration card or register online at www. Proper registration will serve as proof of purchase in the event your original receipt becomes misplaced or lost. Returning this card will expedite the processing of your warranty. Be sure you write your unit's date code on the card before sending it. [. . . ] Returning this card will expedite the processing of your warranty. Be sure you write your unit's date code on the card before sending it. The date code is located on the Power Trigger® of your unit (for example, T087A). The additional information will also help us to develop new products that best meet your needs and desires. [. . . ]