User manual WANDERS ORSANNE

[. . . ] May we take this opportunity to thank you for purchasing one of our products. While we are constructing our fires, we do not only pay the greatest attention to design and appearance, but also to maximizing user-friendliness and reliability. We are therefore fully confident that you will enjoy this appliance for years and years to come. It is important to read these instructions before you install the fire. [. . . ] If a log is broken, it should be replaced. The ceramic glass can be cleaned with a special cleaning product for ceramic cookers or one from your local stockiest. The decorative frame should be wiped with a lint free cloth or soft brush. If there is a crack in the glass window, or if the window is broken, it should be replaced before the gas fireplace can be lit up again. Take great care when handling the ceramic logs as they are very fragile. refer to the diagrams when laying the logs. Only use the logs supplied with the fire and NEVER use alternatives or extra coals or logs. Firstly, fill the burner plate with the enclosed vermiculite chips (check fig 4a). Caution: never use more grains than the supplied amount. Now put the logs in place according to fig. Make sure that when you are putting the logs in place, the pilot flame is not obstructed by either a log or vermiculite chips. The logs must be put in exactly as per these instructions. This is in order to ensure that the flames are impinged as little as possible and thus preventing the disturbance of the flame pattern and possible sooting. Replace the glass window and make sure that it is firmly shut before you light the fire. Place the remote control receiver in the bottom left corner of the unit before you mount the decorative frame (check FIG. Slide the cable between the outer casing and the bottom of the combustion chamber. Batteries required: Handset: 1 x 9V block (alkaline recommended) Receiver: 4 x 1, 5V AA (alkaline recommended) CONNECTIONS The G30-ZRPTT is intended for use only with motorized gas combination controls models GV34 (or GV36 retrofitted with a motor). The receiver cable must be firmly plugged onto the flat blade connectors. The two large buttons on the remote control hand-set are used to operate the main burner. The two smaller buttons are for AUTO and TIMER. SETTING THE DISPLAY After fitting the batteries in the receiver and the hand set, the following options are available: Adjustment of the digital display (from `DEGREES F & 12 HOUR' to `DEGREES C & 24 HOUR' and vice versa) · Now you can switch from F to C and vice-versa by pressing the AUTO button. The display will return to "manual operation" after a short time. [. . . ] This is the spark that ignites the pilot being generated. 3A You will be able to see though the glass window, in the front left corner, if the pilot flame has lit. If the pilot did not light, repeat the previous sequence. (from 2) · If the fire goes out, do not re-ignite for at least 3 minutes. [. . . ]