User manual WAVECOM WINPATS LITE

[. . . ] Asset Management & Maintenance Software Operators Manual for PC REVISION 1. 0 January 2005 Developed by Wavecom Instruments Pty Ltd Distributed by Nesco, Electromate & Appointed Agents. All rights reserved. Congratulations. . . . . You have just purchased a World Leading Product! To ensure that you achieve the full potential of this software please follow the Operators Manual instructions carefully. As we are continuing to improve this product please email winpats@wavecom. com. au to receive any available updates and/or any other information relating to this product. We welcome any comments so that we can continue to provide you with the best product of this kind on the market. Thank you! Page 2 "The Home of Innovative Instrument & Software Technology" www. wavecom. com. au CONTENTS Chapter 1 ­ Important Information WinPATSTM Features . . . . . . . . . . . . . . . . . [. . . ] Tab 3 - COMMENTS Use this tab to record any extra information if required. Once all information has been added to all fields as required Click [OK] again. The site will now be added to the Site list in your New Database. NOTES: 1. There must be at least one Site setup for WinPATS Lite to function normally. Location/s within the Site Details must be added to be able to continue with any tests. Locations required must be in the `Assigned Locations' list and not the `Available Locations' to be available when adding equipment. In the Locations list, you can select multiple locations by holding down `Ctrl' and selecting the required location/s. Selected Locations will be highlighted in dark blue. On the locations tab, all typing will be recorded in capitals. (this is not the case in some of the other tabs/boxes). Double clicking a location in the `Location Name' list will transfer it to the `Assigned Locations' list. Page 29 "The Home of Innovative Instrument & Software Technology" www. wavecom. com. au Chapter 5 ­ WinPATSTM Operation Equipment Equipment Inventory To Add Equipment A single piece of equipment, with an existing barcode 1. 2. Click [Equipment] Click [Add] The following screen will appear. 3. Fill in all required information into each tab section of the `Site Details' Box including the following: i. Type In [Site, Location, Description, Make Model, Serial No, Asset No, Frequency] 4. Scan or enter the barcode (If entering by hand, hit Enter when done) If the barcode is not being used by anything else, you will be asked if you want to add equipment Click Yes If the question does not appear, equipment will be listed that uses the entered barcode. If you are sure the equipment is still new: Click Add (+) on the toolbar. The New Equipment screen will appear Enter the equipment details on the General tab The Test Due Date will default to the current date, unless otherwise adjusted. Click on the Testing tab Set the Testing Frequency Barcode numbers may be entered by a Barcode Scanner. Please consult manufacturer for further details. Page 30 "The Home of Innovative Instrument & Software Technology" www. wavecom. com. au Chapter 5 ­ WinPATSTM Lite Operation Equipment Choose test/s to be done for each piece of equipment. View the Available Test Categories on the right and click the ones to assign. By holding down the Ctrl button you can select many. Selected Test Categories will turn dark blue. Double clicking a Test Category will also assign it. [. . . ] After this has been entered in successfully, you will then be prompted to enter a new password. Passwords must be at least 7 characters long. How do I use WinPATSTM Lite to test with the TnT Appliance Tester?To use WinPATS TM Lite to test with the TnT Appliance Tester you will first need to tell WinPATSTM Lite which COM port the TnT is connected to. [. . . ]