User manual WEED EATER 4000

[. . . ] ENGLISH R Trademark Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. weedeater. com Instruction Manual Manual de Instrucciones Manuel d'Instructions ESPAÑOL 4000C NOT DESIGNED FOR USE WITH ELECTRIC POWERHEADS NO ESTA DISEÑADO PARA EL USO CON CABEZAS DE MOTOR ELÉCTRICO NON CONÇU POUR L'USAGE AVEC BLOC-- MOTEURS ÉLECTRIQUES DANGER: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. [. . . ] Position the second bracket cover over the handlebar. Align the mounting bracket and the bracket cover screw holes. Again make sure the handlebar is at the end of the arrow. Insert two screws and hand tighten only. Be sure the handlebar is installed correctly; then, tighten each screw securely with the hex wrench. Upper Shoulder Strap Clamp POWERHEAD END Lower Shoulder Strap Clamp 3. 4. ATTACHMENT END Screws WARNING: Proper shoulder strap and handlebar adjustments must be made with the engine completely stopped before using unit. The shoulder strap clamp must be installed as shown above the handlebar on the upper shaft (powerhead end of unit). NOTE: The lower shoulder strap clamp has two spacer tabs attached. These tabs are provided to adapt this attachment for use with powerheads that have a 1 diameter upper shaft (the shoulder strap clamp will not tighten down securely on the 1 diameter upper shaft without using these spacer tabs). The tabs must be broken off completely before use and placed over the screw holes on the lower shoulder strap clamp. These tabs are not needed for powerheads with a 7/8 upper shaft. LOWER SHOULDER STRAP CLAMP Spacer Tabs Insert two screws into the screw holes. Secure shoulder strap clamp by tightening screws with the hex wrench. Insert your right arm and head through the shoulder strap and allow it to rest on your left shoulder. Make sure the danger sign is on your back and the hook is to the right side of your waist. Loosen the coupler by turning the knob counterclockwise. Upper Shaft Coupler Lower Attachment LOOSEN INSTALLING OPTIONAL ATTACHMENTS 1. 2. While securely holding the upper shaft, pull the attachment straight out of the coupler. Remove the shaft cap from the attachment (if present) and discard. Position locking/release button of attachment into guide recess of upper shaft coupler. Coupler Primary Hole Guide Recess TIGHTEN Knob 3. 4. Locking/ Attachment Release Button Push the attachment into the coupler until the locking/release button snaps into the primary hole. Before using the unit, tighten the knob securely by turning clockwise. [. . . ] NOTE: Make sure all parts are in place as illustrated, and the blade is sandwiched between the dust cup and the retaining washer. There should be no space between the blade and the dust cup or the retaining washer. 8. Tighten blade nut firmly with a wrench while holding screwdriver in position. If the blade binds against the shield, or appears to be uneven, the blade is not centered, and you must reinstall. STORAGE steps after each use: S Allow attachment and gearbox to cool before storing or transporting. S Store attachment with blade shield in place. [. . . ]