User manual WEED EATER EBV

[. . . ] ENGLISH R Trademark Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. weedeater. com Instruction Manual Manual de Instrucciones Manuel d'Instructions EBV VS FOR HOUSEHOLD USE ONLY PARA USO CASERO SOLAMENTE POUR UTILISATION À DES FINS DOMESTIQUES SEULEMENT WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. [. . . ] Do not vacuum stones, gravel, metal, broken glass, etc. , to avoid severe damage to the impeller. To avoid the possibility of electrical shock, do not attempt to vacuum water or other liquids. S Never run the unit without the proper equipment attached. When used as a vacuum, always install vacuum tubes and collection bag assembly. Make sure the collection bag assembly is completely zipped when unit is running to avoid flying debris. S Avoid situations which could set the collection bag on fire. To remove the blower tube, press the tube release button while pulling on tube. Tube Release Button Blower Tube Blower outlet Inlet Restrictor 1. Ensure unit is stopped and extension cord is unplugged. Open the inlet cover by inserting the tip of a screwdriver into the latch area on the blower unit. Gently tilt handle of screwdriver toward the front of the unit to release the latch while pulling up on the vacuum inlet cover with your other hand. Bottom view of unit Latch Area Vacuum Inlet Cover (closed) Impeller Latch Area Vacuum Inlet Cover (opened) 3. Turn the inlet restrictor counterclockwise and remove it from the unit. You will next attach the vacuum tubes. Vacuum Inlet Cover VACUUM ASSEMBLY NOTE: Assembly instructions for using your unit as a blower are explained in the previous section. If you have already assembled your unit for use as a blower, remove the blower tube. CAUTION: To avoid causing damage to the unit, DO NOT attempt to use the variable speed control during vacuum use. Remove the inlet restrictor An inlet restrictor is used when using your unit as a blower. This restrictor is not used during vacuum use and must be removed during assembly for vacuum use. NOTE: Be sure to keep the inlet restrictor for using your unit as a blower. 5 Attaching the vacuum tubes There are 2 vacuum tubes, an upper tube and a lower tube. The upper tube has a vacuum assist handle attached to one end and is cut straight on both ends. The upper tube attaches to the blower unit. The lower tube has an angled end that you point toward the ground during vacuum use. The lower tube attaches to the upper tube. Ensure unit is stopped and extension cord is unplugged. [. . . ] If cracked or damaged, do not use the unit. Have parts replaced by your authorized service dealer. Do not attempt to replace them yourself. WARNING: Stop the unit and disconnect from the power source before opening the inlet cover. The motor must be stopped and the impeller blades no longer turning to avoid serious injury from the rotating blades. STORAGE steps after each use: S Stop unit and disconnect from the power source. [. . . ]