User manual WEED EATER RTE115C

[. . . ] ENGLISH R Trademark Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. weedeater. com Instruction Manual Manual de Instrucciones Manuel d'Instructions ESPAÑOL RTE115C WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Read instructions carefully before assembling. [. . . ] Remove objects (rocks, broken glass, nails, wire, string, etc. ) which can be thrown or become entangled in cutting head. S Do not overreach or stand on unstable support. S Keep the cutting head below waist level. Cutting head can come dangerously close to your body. S Keep away from cutting head and spinning line. Use only for trimming, edging, scalping, and mowing. It will do the job better and with less risk of injury at the rate for which it was designed. S Use only in daylight or in good artificial light. WARNING: All electrical repairs to this unit, including housing, switch, motor, locking sleeve assembly, wires, etc. , must be diagnosed and repaired by qualified service personnel. Replacement parts for a double insulated appliance must be recommended by the manufacturer. A double insulated appliance is marked with the words "double insulation" or "double insulated". The symbol may also be (square within a square) marked on the appliance. Failure to have the unit repaired by qualified service personnel can cause the double insulation construction to become ineffective and result in serious injury. SAVE THESE INSTRUCTIONS MAINTENANCE SAFETY WARNING: Disconnect unit from the power supply before performing maintenance, or when changing trimmer line. 3 ASSEMBLY WARNING: If received assembled, review all assembly steps to ensure your unit is properly assembled and all fasteners are secure. TUBE ASSEMBLY Upper Locking Sleeve Assembly WARNING: The upper and lower tubes must be snapped together, remain permanently assembled together and the locking sleeve assembly must be fully tightened before and during use to avoid serious injury to the operator and/or damage to the unit. DO NOT attempt to disassemble unit after initial assembly. ADJUSTING ASSIST HANDLE 1. Loosen and remove wing nut and bolt from assist handle. Firmly push the assist handle over the tube. To make installation easier, tilt handle toward trigger housing while pushing down (see illustration). Adjust the handle up or down the tube to a comfortable position; tighten wing nut securely. Assist handle Trigger housing Tube Wires Lower Locking Sleeve Assembly 1. Align upper tube groove with triangle on lower locking sleeve assembly. Push tubes together until they snap into place. [. . . ] Only tighten cap hand tight! Spool USER REPLACEABLE SERVICE PARTS REPLACEMENT PART Spool with 0. 065 inch Trimmer Line Line Guide Ring Cap Assembly Assist Handle Bolt Carriage, 1/4-20 Wing Nut Shield Assembly Edge Guide PART NUMBER 952711602 530403949 530403810 530403805 530403886 530016152 530403914 530403824 STORAGE WARNING: Perform the following steps after each use. S Stop the unit and disconnect the power source when not in use. S Store the unit so the line limiter blade cannot cause injury. S Store unit and extension cord indoors in a high, dry place out of the reach of children. Position unit so that any sharp object cannot accidentally cause injury. 8 TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect from the power source before performing all of the recommended remedies below except remedies that require unit to be operating. CAUSE 1. [. . . ]