User manual WEED EATER TE500 CXL

[. . . ] ENGLISH R Trademark Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. weedeater. com Operator's Manual Manual del Operador Manuel de L'utilisateur TE 500 CXL ESPAÑOL UL R For Occasional Use Only WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. [. . . ] S Pivot handle to a comfortable position. Tighten handle securely. ATTACHING THE SHIELD WARNING: The shield must be properly installed. The shield provides partial protection from the risk of thrown objects to the operator and others and is equipped with a line limiter which cuts excess line. The line limiter (on underside of shield) is sharp and can cut you. S Pivot shield until bolt passes through hole in bracket. S Securely tighten wing nut. Slot Shield Bracket Wing Nut 3 FUEL YOUR UNIT WARNING: Remove fuel cap slowly when refueling. This engine is certified to operate on unleaded gasoline. Gasoline must be mixed with a good quality 2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. (A 40:1 ratio is obtained by mixing 3. 2 ounces of oil with 1 gallon of unleaded gasoline). When mixing fuel follow the instructions printed on the container. Always read and follow the safety rules under FUEL SAFETY. STARTING A WARM ENGINE S S S S Move ON/OFF switch to the ON position. Pull starter rope handle until engine runs. If engine does not start in 5 pulls, follow instructions in STARTING A COLD ENGINE. USING YOUR UNIT OPERATING POSITION ALWAYS WEAR: Eye Protection STARTING HOW TO STOP YOUR UNIT To stop engine, move ON/OFF switch to the OFF position. Long Pants Heavy Shoes Cut from your right to your left. HOW TO START YOUR UNIT TRIMMER LINE ADVANCE Starting Position The cutting head advances line automatically. Do not tap head on the ground to advance line. This may break parts and cause cutting head to malfunction. Upon unit start up, the line will advance automatically to the correct cutting path length. Always keep the shield in place when the tool is being operated. Muffler Choke lever Trigger Primer Bulb TWIST- -EDGE -NS Pull the tab toward the engine. S Twist the tube to the edging position; release the tab. WARNING: The trimmer head will turn while starting the engine. A hot muffler can cause serious burns. STARTING A COLD ENGINE (or a warm engine after running out of fuel) S S S S S S S S S Set unit on a flat surface. Move choke lever to FULL CHOKE position. Squeeze the throttle trigger fully and hold through all remaining steps. [. . . ] MANUFACTURER'S WARRANTY COVERAGE: If any emissions related part on your engine (as listed under Emissions Control Warranty Parts List) is defective or a defect in the materials or workmanship of the engine causes the failure of such an emission related part, the part will be repaired or replaced by POULAN/ WEED EATER. OWNER'S WARRANTY RESPONSIBILITIES: As the lawn and garden equipment engine owner, you are responsible for the performance of the required maintenance listed in your Owner's Manual. POULAN/ WEED EATER recommends that you retain all receipts covering maintenance on your lawn and garden equipment engine, but POULAN/ WEED EATER cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the lawn and garden equipment engine owner, you should be aware that POULAN/WEED EATER may deny you warranty coverage if your lawn and garden equipment engine or a part of it has failed due to abuse, neglect, improper maintenance, unapproved modifications, or the use of parts not made or approved by the original equipment manufacturer. [. . . ]