User manual WEED EATER WEEL15TNE

[. . . ] ENGLISH Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. Register your product online at: Registre su producto en línea en: Enregistrez votre produit en ligne à l'adresse : www. weedeater. com 1-800-554-6723 245157 Instruction Manual Manual de Instrucciones Manuel d'Instructions WE EL-15TNE ESPAÑOL WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. [. . . ] It will do the job better and with less risk of injury at the rate for which it was designed. Use only in daylight or in good artificial light. This unit is double insulated to help protect against electric shock. Double insulation construction consists of two separate "layers" of electrical insulation instead of grounding. Tools built with this insulation system are not intended to be grounded. No grounding means is provided on this unit, nor should a means of grounding be added to this unit. As a result, the extension cord used with your unit can be plugged into any standard 120 volt electrical outlet. Safety precautions must be observed when operating any electrical tool. The double insulation system only provides added protection against injury resulting from an internal electrical insulation failure. DOUBLE INSULATION CONSTRUCTION WARNING: All electrical repairs to this unit, including housing, switch, motor, locking sleeve assembly, wires, etc. , must be diagnosed and repaired by qualified service personnel. Replacement parts for a double insulated appliance must be recommended by the manufacturer. A double insulated appliance is marked with the words "double insulation" or "double insulated". The symbol (square within a square) may also be marked on the appliance. Failure to have the unit repaired by qualified service personnel can cause the double insulation construction to become ineffective and result in serious injury. SAVE THESE INSTRUCTIONS 3 ASSEMBLY WARNING: If received assembled, review all assembly steps to ensure your unit is properly assembled and all fasteners are secure. TUBE ASSEMBLY Wire protector Upper Locking Sleeve Assembly WARNING: The upper and lower tubes must be snapped together, remain permanently assembled together and the locking sleeve assembly must be fully tightened before and during use to avoid serious injury to the operator and/or damage to the unit. DO NOT attempt to disassemble unit after initial assembly. INSTALLATION OF ASSIST HANDLE 1. Push assist handle over the clamp on the tube (see illustration). Handle can be assembled as option 1 or 2 (Shown Below) depending on the users preference. Adjust the handle up and down the tube and pivot it to a comfortable position; tighten knob securely. Assist handle Wires Lower Locking Sleeve Assembly 1. Remove the wire protector from the tubes and discard. Align upper tube groove with triangle on lower locking sleeve assembly. Push tubes together until they snap into place. Upper Tube Groove Alignment Triangle 3. If the tubes do not come apart, they are properly snapped into place. [. . . ] · Store unit with all guards in place. Position unit so that any sharp object cannot accidentally cause injury. TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect from the power source before performing all of the recommended remedies below except remedies that require unit to be operating. Trimmer head 1. Crowding trimmer line stops under a against material being load or does not cut. Line improperly routed advance or in head. [. . . ]