User manual WEED EATER WEF550

[. . . ] ADVERTENCIA: Lea el manual del operador y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en lesiones graves. AVERTISSEMENT: Lire le manuel de l'utilisateur et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. Electrolux Home Products, Augusta, GA 30907 WCI Outdoor Products, Inc. 530087645 8/31/00 FRANÇAIS SAFETY RULES DANGER: This power tool can be dangerous! [. . . ] Be sure to wear gloves while working with blades. S If your unit has a plastic cover over the threads on the shaft, remove the covering to expose the threads. S Place the metal shield under the gearbox, and align the screw holes. NOTE: The dust cup and retaining washer are located on the gearbox and not in the parts bag. S Remove the retainer washer from the gearbox, and leave the dust cup on the gearbox. NOTE: It may be necessary to remove a plastic protective covering from the threaded shaft before removing the retaining washer. Dust Cup Retaining Washer S Install the blade over the threaded shaft extending from the gearbox between the dust cup and the retaining washer. Make sure 6 the raised part of the retaining washer is facing the gearbox, and the raised area fits into the hole in the center of the blade. S Slide the blade and retaining washer onto the shaft of the gearbox. S Now place the cupped washer onto the shaft. Make sure the cupped side of the washer is toward the blade. S Install the blade nut by threading onto the shaft counterclockwise. parts. Be sure to store parts and instructions for future use. FUEL YOUR UNIT This engine is certified to operate on unleaded gasoline. Gasoline must be mixed with a good quality 2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. NOTE: To remove blade, insert hex wrench into aligned holes. Un-thread nut and remove COLD ENGINE OR WARM ENGINE AFTER RUNNING OUT OF FUEL S Rest engine and shield on ground, supporting trimmer head off ground. S Move the switch to the ON position. 7 S Slowly press the primer bulb 6 times. S Move choke lever to FULL CHOKE position. Starter Handle Choke OPERATING INSTRUCTIONS FOR USE WITH TRIMMER HEAD Primer Bulb Muffler S Activate the throttle lock. Keep throttle trigger in the starting position until engine runs smoothly. S Pull starter rope handle sharply 6 times. S Move choke lever to HALF CHOKE position. S Pull starter rope sharply no more than 6 pulls, until engine runs. S Allow engine to run 10 seconds, then move choke lever to OFF CHOKE position. Allow unit to run for 30 more seconds at OFF CHOKE before releasing throttle trigger from the starting position. [. . . ] All new utility and lawn and garden equipment engines must be designed, built, and equipped to meet the stringent anti--smog standards. POULAN/WEED EATER must warrant the emission control system on your lawn and garden equipment engine for the periods of time listed below provided there has been no abuse, neglect, or improper maintenance of your lawn and garden equipment engine. Your emission control system includes parts such as the carburetor and the ignition system. Where a warrantable condition exits, POULAN/WEED EATER will repair your lawn and garden equipment engine at no cost to you. [. . . ]