User manual WEED EATER XT110

[. . . ] ENGLISH R Trademark Please do not return product to retailer. Por favor, no devuelva el producto al lugar de compra. Veuillez ne pas retourner le produit au détaillant. 1-800-554-6723 Register your product online at: Registre su producto en línea en: Enregistrez votre produit en ligne à l'adresse : www. weedeater. com Instruction Manual Manual de Instrucciones Manuel d'Instructions SG / TE / XT Series WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Read instructions carefully before assembling. [. . . ] Do not expose cords to heat, oil, water, or sharp edges. S To avoid the possibility of electric shock, avoid body contact with any grounded conductor, such as metal fences or pipes. S Ground Fault Circuit Interrupter (GFCI) protection should be provided on circuit or outlet to be used. Receptacles are available having built-in GFCI protection and may be used for this measure of safety. Make sure all handles, guards, and fasteners are in place and securely fastened. Parts that are damaged must be repaired or replaced by an authorized service dealer. This includes head parts that are cracked, or chipped, guards, and any other part that is damaged. S Use only 0. 065" (1. 65 mm) diameter recommended trimmer line (see ACCESORIES). Make sure spool is properly installed and all parts are securely fastened. S Use only recommended WEED EATER replacement parts and accessories. CUTTING SAFETY S Inspect area to be cut. Remove objects (rocks, broken glass, nails, wire, string, etc. ) which can be thrown or become entangled in cutting head. S Do not overreach or stand on unstable support. S Keep the cutting head below waist level. Cutting head can come dangerously close to your body. S Keep away from cutting head and spinning line. Use only for trimming, edging, and mowing. Do not force unit; it will do the job better and with less risk of injury at the rate for which it was designed. S Use only in daylight or in good artificial light. MAINTENANCE SAFETY WARNING: Disconnect unit from the power supply before performing maintenance, or when changing trimmer line. S Maintain unit according to recommended procedures. Follow instructions for changing trimmer line. S Have all service and maintenance not explained in this manual performed by an authorized service dealer to avoid creating a hazard. [. . . ] Position unit so that any sharp object cannot accidentally cause injury. S Wind the line evenly and tightly onto the spool. Wind in the direction of the arrow found on the spool. S Push the line into the notch, leaving 3 to 5 inches (7 -- 12 cm) unwound. S Insert the line into the exit hole in the hub as shown in the illustration. Line in Notch NEED ASSISTANCE? For assistance, or a replacement part call: 1-800-554-6723. [. . . ]