User manual WEED EATER XT700

[. . . ] ENGLISH R Trademark Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. weedeater. com Instruction Manual Manual de Instrucciones Manuel d'Instructions ESPAÑOL XT700 MX550 For Occasional Use Only WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. [. . . ] S Hold the trimmer head parallel to and above the grassy area. S Tap the bottom of the trimmer head lightly on the ground one time. Approximately 2 inches (5 cm) of line will be advanced with each tap. 1. Move the choke lever to the HALF CHOKE position. Keep throttle trigger fully squeezed until the engine runs smoothly. Pull starter rope sharply until engine runs, but no more than 6 pulls. Allow engine to run 15 seconds, then move the choke lever to the RUN position. NOTE: If engine has not started, pull starter rope 5 more pulls. If engine still does not run, it is probably flooded. STARTING A WARM ENGINE 7 Always tap the trimmer head on a grassy area. Tapping on surfaces such as concrete or asphalt can cause excessive wear to the trimmer head. If the line is worn down to 2 inches (5 cm) or less, more than one tap will be required to obtain the most efficient line length. WARNING: Use only 0. 080 (2 mm) diameter line. Other sizes of line will not advance properly and can cause serious injury. Do not use other materials such as wire, string, rope, etc. Wire can break off during cutting and become a dangerous missile that can cause serious injury. CUTTING METHODS SCALPING - The scalping technique removes unwanted vegetation. Hold the bottom of the trimmer head about 3 inches (8 cm) above the ground and at an angle. Allow the tip of the line to strike the ground around trees, posts, monuments, etc. This technique increases line wear. WARNING: Use minimum speed and do not crowd the line when cutting around hard objects (rock, gravel, fence posts, etc. ), which can damage the trimmer head, become entangled in the line, or be thrown causing a serious hazard. You will achieve the best performance and minimum line wear by not crowding the line into the cutting area. The right and wrong ways are shown below. Tip of line does Line crowded into the cutting. work area. MOWING - Your trimmer is ideal for mowing in places conventional lawn mowers cannot reach. In the mowing position, keep the line parallel to the ground. [. . . ] WEED EATER recommends that you retain all receipts covering maintenance on your small off-road engine, but WEED EATER cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the small off-road engine owner, you should be aware that WEED EATER may deny you warranty coverage if your small off-road engine or a part of it has 13 failed due to abuse, neglect, improper maintenance, unapproved modifications, or the use of parts not made or approved by the original equipment manufacturer. You are responsible for presenting your small off-road engine to an WEED EATER authorized repair center as soon as a problem exists. Warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. [. . . ]