User manual WEEDEATER XT85 PARTS LIST

[. . . ] ADVERTENCIA: Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en lesiones graves. AVERTISSEMENT: Lire le manuel d'instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. Electrolux Home Products, Inc. [. . . ] Pull starter rope sharply until engine runs, but no more than 6 pulls. Allow engine to run 15 seconds, then move the choke lever to RUN. NOTE: If engine has not started, pull starter rope 5 more pulls. If engine still does not run, it is probably flooded. 2. STARTING A WARM ENGINE 1. Pull starter rope handle sharply until engine sounds as if it is trying to start, but do not pull rope more than 6 times. As soon as engine sounds as if it is trying to start, move choke lever to HALF CHOKE position. Pull starter rope sharply until engine runs, but no more than 6 pulls. NOTE: If the engine doesn't start after 6 pulls (at the HALF CHOKE position), move the choke lever to the FULL CHOKE position and press the primer bulb 6 times. Squeeze and hold the throttle trigger and pull the starter rope 2 more times. Move the choke lever to the HALF CHOKE position and pull the starter rope until the engine runs, but no more than 6 pulls. If the engine still doesn't start, it is probably flooded. Mowing EDGING - Adjust trimmer to the edging position (see TWIST AND EDGE section). Allow only the tip of the line to make contact. Do not force trimmer line into work area. Edging MAINTENANCE WARNING: Disconnect the spark plug before performing maintenance except for carburetor adjustments. repairs other than the recommended maintenance described in the instruction manual performed by an authorized service dealer. If any dealer other than an authorized service dealer performs work on the product, Electrolux Home Products, Inc. , may not pay for repairs under warranty. It is your responsibility to maintain and perform general maintenance. CHECK FOR DAMAGED OR WORN PARTS Contact an authorized service dealer for replacement of damaged or worn parts. S STOP Switch - Ensure STOP switch functions properly by pushing and holding the switch in the STOP position. S Fuel Tank - Discontinue use of unit if fuel tank shows signs of damage or leaks. S Debris Shield - Discontinue use of unit if debris shield is damaged. IMPORTANT: Have all HELPFUL TIP INSPECT AND CLEAN UNIT AND LABELS CHECK FOR LOOSE FASTENERS AND PARTS S S S S S Spark Plug Boot Air Filter Housing Screws Assist Handle Screws Debris Shield S After each use, inspect complete unit for loose or damaged parts. Clean the unit and labels using a damp cloth with a mild detergent. S Wipe off unit with a clean dry cloth. CLEAN AIR FILTER A dirty air filter decreases engine performance and increases fuel consumption and harmful emissions. Always clean after every 5 hours of operation. 7 1. Clean the air filter cover and the area around it to keep dirt from falling into the carburetor chamber when the cover is opened. [. . . ] Your emission control system includes parts such as the carburetor and the ignition system. Where a warrantable condition exists, ELECTROLUX HOME PRODUCTS, INC. , will repair your small off-road engine engine at no cost to you. Expenses covered under warranty include diagnosis, parts and labor. MANUFACTURER'S WARRANTY COVERAGE: If any emissions related part on your engine (as listed under Emissions Control Warranty Parts List) is defective or a defect in the materials or workmanship of the engine causes the failure of such an emission related part, the part will be repaired or replaced by ELECTROLUX HOME PRODUCTS, INC. [. . . ]