User manual WEEMOTE WEEMOTE 2 QUICK GUIDE

[. . . ] Fobis Technologies Inc. "designing gadgets for real life" Mute PWR INTRODUCTION This installation guide is designed to get your weemote® 2 setup as quickly as possible. In order to ensure a fast setup, please follow this guide, step-by-step, in the order presented. Doing so will save you from possible confusion and frustration later. The companion "REFERENCE GUIDE" provides more detail for those who need more information, have complex entertainment systems or wish to further customize the Weemote's setup. [. . . ] In our example, we are using the Scientific Atlanta code number 003. Press the "1" button 3 times = 3 In this example, there is no need to use the "100" and "10" buttons as the channel number is below 10. Press the "STB" button again to set the code. The LED should flash three times and then turn off to confirm that the code was entered. 1. Write the TV code down on the battery sticker located behind the battery door. If you are also using a Set-Top box, then you will need to proceed directly to STEP 10. Go ahead and reattach the Setup area cover and battery cover. DO NOT OVERTIGHTEN THE SCREWS!!! Need help?Go to www. weemote. com 11 Need help?Go to www. weemote. com 12 STEP 10 CONTINUED STEP 12 TEST THE SET-TOP CODE 8. Press the RED power button to see if the SetTop box turns off (*See Note Below). If it does not, then go back to the beginning of Step 10, using the next code number listed for your manufacturer. If you have run through all the possible codes and still cannot get the Set-Top box to power off, then please refer to the Reference Guide on how to search for your code. * Some codes may operate channel changing but not power. If you leave your Set-Top normally on, then you can use one of these codes. In this case, for each code tested, try to see if you can change channels by pressing the channel up/down button (long blue button) By using one of these codes, the weemote® will not power the Set-Top box on/off. IMPORTANT NOTE: If your Set-Top box is set to use Channel 2, 4, 5 on your TV or your TV is cabled using direct video connections (RCA Jacks or S-Video), then please go to Page 16 to set the Channels/Direct Video option, then come back to this Step. Make sure your TV and Set-Top box is turned off. Point the Weemote® at your Set-Top box and press the Power (red) button. The Set-Top box should go on as well as the TV. Now, check the volume up/down button as well as the channel up/down button. If all these functions work, then you have the right code for your SetTop box. If any of the functions above do not work, then you will need to try another Set-Top code. Go back and repeat Step 10. STEP HOW DO YOU USE YOUR EXISTING SET-TOP REMOTE CONTROL? 11 1. [. . . ] Liquids may contain minerals that can corrode the case and electronics. Use and store the weemote® only in normal temperature environments. Temperature extremes can shorten the life of the electronics, warp the plastic body and cause the batteries to leak. Keep the weemote® away from excessive dust, dirt or sand. [. . . ]