User manual WESTERN DIGITAL STUDIO EDITION II

[. . . ] External Desktop My Book Studio Edition II TM ® User Manual Table of Contents 1 WD Service and Support . 3 Recording Your WD Product Information . 23 TABLE OF CONTENTS ­ i 8 Turning Off/Disconnecting the Device . . 33 TABLE OF CONTENTS ­ ii MY BOOK STUDIO EDITION II USER MANUAL 1 WD Service and Support Should you encounter any problem, please give us an opportunity to address it before returning this product. [. . . ] When prompted to confirm, click Configure again. As standard precaution, the system prompts you for an administrator's name and password to authenticate your action. Enter this information and click OK. When configuring the device, WD RAID Manager automatically formats the disk as a single volume using the format and RAID type specified. FAT32 formats with a Master Boot Record partition map for Windows compatibility. The HFS+ setting formats with an HFS Extended w/ Journal volume using a partition map type which best matches the Macintosh model the drive is currently connected to. On Macintosh computers with PowerPC processor(s), an Apple Partition Map structure is created. On Macintosh computers with Intel processor(s), a GUID Partition Table is created. For information on how to make your My Book bootable on an Intel-based Macintosh, go to support. wdc. com and search for answer ID# 1787. WD RAID MANAGER FOR MAC ­ 18 MY BOOK STUDIO EDITION II USER MANUAL RAID Troubleshooting WD RAID Manager monitors the activity of the drives in the RAID system so you can view the status of each drive and take the appropriate action. To view the device status as well as the status of each internal hard drive, including which drive (A or B) may have experienced a fault, click on a device and then click Info, which brings up a drawer on the right hand side of the main window. WD RAID MANAGER FOR MAC ­ 19 MY BOOK STUDIO EDITION II USER MANUAL RAID Status Messages WD RAID Manager reports the following messages depending on the current status of your drive. Displayed Status Text Healthy Description Array is properly configured and operating normally. Drives from different RAID sets detected in slots. User Action None Setting Mismatched Both slots have valid array configurations, but they do not agree on the settings and the device is not able to determine which configuration is newer. Install another drive that is not part of a different RAID array. Install the original drive that is part of the RAID array. Create a new array with the installed drives. Degraded The array configuration is valid and is currently RAID1, but one slot is marked as faulty. The array configuration is valid, but one slot is being rebuilt from the other slot. RAID 1 only Consult the slot status values to determine which slot is faulty and replace the drive. RAID 1 only Recovering from degraded mode. (This may take several hours. ) Check disk status. See "Disk Status Messages" on page 21. RAID Status Rebuilding Bad Neither slot contains a valid array configuration. WD RAID MANAGER FOR MAC ­ 20 MY BOOK STUDIO EDITION II USER MANUAL Disk Status Messages WD RAID Manager reports the following messages depending on the current status of your Disk A and B. Displayed Status Text Good Description The slot configuration contains valid data. Consult the array status to see if other errors have been detected. The slot contains no HDD The slot does not contain a valid configuration. User Action None No hard disk No Config Install drive in empty slot. [. . . ] If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual. MIC Notice (Republic of Korea only) Class B Device 1 Please note that this device has been approved for non-business purposes and may be used in any environment, including residential areas. Environmental Compliance (China) (Pb) O O O O O O O O O O O O O X O O O (PCB) (Cd) O O O O O O O O O O O O O O O O O (Hg) O O O O O O O O O O O O O O O O O IC MCV MCV (Cr6+) O O O O O O O O O O O O O O O O O O O O O O O O O O O O O O O O O O (PBB) O O O O O O O O O O O O O O O O O (PBDE) HDD EMI Kensington 6-32x6. 35mm M3x5mm+5W (PCA)* * O X APPENDIX ­ 31 MY BOOK STUDIO EDITION II USER MANUAL Warranty Information Obtaining Service WD values your business and always attempts to provide you the very best of service. If this Product requires maintenance, either contact the dealer from whom you originally purchased the Product or visit our product support Web site at support. wdc. com for information on how to obtain service or a Return Material Authorization (RMA). If it is determined that the Product may be defective, you will be given an RMA number and instructions for Product return. [. . . ]