User manual WESTERN DIGITAL WD CAVIAR SE QUICK INSTALLATION GUIDE

[. . . ] Internal Desktop WD Caviar SE ® EIDE Hard Drive Quick Install Guide This document was designed to aid in the quick installation of your new WD EIDE hard drive. For further information regarding the installation and use of your drive, visit our website at support. wdc. com. Kit Contents Compatibility Windows® XP (SP 1 or higher needed for drives >137 GB) Windows 2000 (SP 3 or higher needed for drives >137 GB) Windows Me and Windows 98SE (may require an Ultra ATA controller card) Mac® OS X v10. 2 or later requires a Mac-compatible ATA controller card (for drives larger than 137 GB) Operating System Information Installing Your New WD Hard Drive as an Upgrade From a Previously Installed Hard Drive To ensure the optimal settings for your drive configuration, we recommend you run the Installation Tutorial in the Windows version of Data Lifeguard ToolsTM prior to the hardware installation. Data Lifeguard Tools for Windows will generate your custom installation instructions based on the configuration you choose. For more information on using Data Lifeguard Tools, visit our website at support. wdc. com. [. . . ] To install a hard drive smaller than 137 GB as an additional hard drive in a Power Mac, change the configuration to Slave (see page 2 for a diagram of the jumper block). The drive that came with the Macintosh is already designated as Master (Master ID=0, Slave ID=1). To mount the hard drive in your Macintosh, follow the instructions from your Apple Setup Guide. Note: Cable Select mode is not supported by Macintosh's built-in IDE/ATA controller. You must use the Master/Slave jumper setting. Figure 5 Windows 2000 or XP: For advanced users, see "Alternate Setup" below. Windows 98SE or Me: If your hard drive is larger than 137 GB, you will need to use the DOS version of Data Lifeguard Tools to maximize the full capacity of your drive. Insert the Data Lifeguard Tools CD into the CD-ROM drive. Autorun the CD to use the Windows version (Figure 5) or boot your system to the CD for the DOS version. If unable to boot to CD, boot from the Data Lifeguard Tools diskette. Execute the Diskette Creator program on the Data Lifeguard Tools CD to create the diskette. The software will scan and detect the newly installed hard drive. Set up your new hard drive by carefully following the on-screen instructions. Select the Advanced Installation or Custom Partition option to create partitions during setup. Remove the Data Lifeguard Tools CD and reboot the system. At the end of the program, Data Lifeguard Tools will indicate a successful setup or provide further details. This concludes the hard drive installation process. Alternate Setup Instructions for Windows 2000/XP Install a Single Hard Drive: 1. Boot to the Windows 2000/XP Installation CD. Follow the directions in the installation prompt. Install an Additional Hard Drive in Windows: 1. Click the Start button and point to Settings > Control Panel > Administrative Tools. Double-click on the Computer Management icon and select Disk Management on the left side. [. . . ] Disclaimer of Warranties There are no warranties which extend beyond the face of the WD limited warranty. WD disclaims all other warranties, expressed or implied, regarding the Products, including any implied warranties of merchantability, fitness for a particular purpose or noninfringement. In the United States, some laws do not allow the exclusion of the implied warranties. Your Use of the Product WD will have no liability for any Product returned if WD determines that: · The product was stolen from WD. cannot reasonably be fixed because of damage occurring when the Product was in the possession of someone other than WD, or c. [. . . ]