User manual WHIRLPOOL 001 506 26 INSTRUCTION FOR USE

[. . . ] • The power cable must be long enough to make the electrical connection of the oven fitted in the cabinet. • The safety directives require a multi-pole switch with contact gap of at least 3 mm to be used during installation. • After installation, the electrical components must be inaccessible. Connecting the oven to the power supply • Make sure the voltage indicated on the dataplate is the same as the mains voltage. The dataplate is on the front edge of the oven (visible when the door is open). [. . . ] • Do not allow children to touch: - the oven and its controls, especially when it is on and immediately afterwards, to avoid injury; - packing materials (bags, polystyrene, metal parts, etc. ); - the oven to be scrapped. • Make sure the electrical cables of other appliances used near the oven do not touch hot parts and are not caught in the oven door. • Some oven models have an air cooling system to prevent the front of the oven and cabinet recess from becoming too hot. Caution: Hot air comes out through an opening located between the control panel and the oven door. Therefore do not obstruct the ventilation openings. • Do not place flammable materials in the oven or near it: they could catch fire if the appliance is inadvertently switched on. • Use oven gloves to remove pans and accessories when the oven is hot. rum, cognac, wine, etc. ) are added when roasting or baking cakes, remember that alcohol evaporates at high temperatures. Alcohol vapours can catch fire when coming into contact with the electrical heating element. • Do not heat or cook food in closed containers in the oven. The pressure created inside could cause them to burst, damaging the oven. • For cooking do not use containers made of synthetic material (unless specific for oven use; see the Manufacturer's instructions). • Pay attention when cooking with oil and fat. In fact, the oil and fat could overheat and cause a fire!• Do not pull out fully loaded accessories. Be very careful. BEFORE USING THE OVEN • Remove the accessories from the oven and heat it at 200 °C for about an hour to eliminate the odours and fumes of the insulating material and protective greases. It is advisable to keep the window open during this operation. • Before using the appliance, remove: - stickers on the front and oven door, except for the dataplate; - cardboard protection and protective plastic film from the control panel and other parts of the oven; - any adhesive labels from the accessories (e. g. under the drip-tray). 16 61002001. book Page 17 Tuesday, March 25, 2008 4:46 PM OVEN ACCESSORIES The accessories supplied depend on the model. The accessories provided with the oven are listed in the separate Product Sheet (under Accessories). Drip-tray (1) For collecting fat and bits of food when placed under the wire shelf, or as a plate for cooking meat, chicken and fish, etc. , with or without vegetables. Pour a little water into the drip-tray to prevent spatters of fat and smoke. 1 Baking tray (2) For baking biscuits, cakes and pizzas. 2 Wire shelf (3) For grilling food or as a support for pots, cake tins and other cooking receptacle. It can be placed on any available level. The wire shelf can be inserted with its curvature facing up or down. 3 Catalytic side panels (4) These panels have a special microporous enamel coating that absorbs fat spatters. [. . . ] If the fault persists after the above checks, contact the nearest After-Sales Service. Always specify: •a brief description of the fault; •the exact oven model and type; •the After-Sales Service number (number after the word Service on the dataplate), located on the right inside edge of the oven compartment (visible when the door is open). The AfterSales Service number is also given in the warranty booklet; •your full address; •your telephone number. If any repairs are required, contact an authorised Technical Service Centre (to guarantee the use of original spare parts and correct repair). [. . . ]