User manual WHIRLPOOL 001 576 99 INSTRUCTION FOR USE

[. . . ] NUTID FCF191/100 GB ENGLISH 4 ENGLISH 4 Contents Safety information Product description First use Daily use Cleaning and maintenance What to do if . . . 4 6 7 7 9 1 1 Technical data Environmental concerns Electrical connection for Great Britain and Ireland only IKEA GUARANTEE 14 14 15 16 Safety Information Before first use This appliance is intended to be used in household. To ensure best use of your appliance, carefully read this User Manual which contains a description of the product and useful advice. Keep these instructions for future reference. [. . . ] Close and fix both doors with adhesive tape and, again using adhesive tape, fix the power cable to the appliance. If the appliance is not going to be used Disconnect the appliance from the power supply, remove all the food, defrost and clean. Leave the doors open enough for air to circulate inside the compartments. This will prevent the formation of mould and bad odours. In case of power failures Call the local office of your electricity supply company and ask how long it is going to last. For power failures lasting up to 24 hours. Keep both doors of the appliance closed. This will allow the stored food to stay cold as long as possible. For power failures lasting more than 24 hours. Empty the freezer compartment and arrange the food in a portable freezer. If this type of freezer is not available and, likewise, no artificial ice packs are available, try to use up the food, which is more easily perishable. (see Notes) Possible cause The appliance is not installed properly. The storage inside appliance is not correct. Solution Check if the appliance stands stable (all the feet should be on the floor). Check that: - The internal components are correctly placed. - Bottles and containers are not in contact with each other. The appliance does not operate There might be a Check that: problem with the electric - there isn’t a power supply failure. power supply to the - the power plug is correctly appliance. inserted in the power socket and the two-pole switch, if present, is in the correct position (on). - the electric circuit safety devices installed in the house are fully functional. The appliance is switched off Switch on the appliance. Disconnect the appliance from the electric power supply, check the lamp and replace with a new one if necessary (see “Daily Use”). Disconnect the appliance from the electric power supply, check the lamp and screw the lamp. The inside light does not work - The lamp might need replacing - The lamp is fixed incorrectly ENGLISH 12 Problem The temperature inside the compartments is not cold enough. [. . . ] Unless such damages can be proved to have been caused by production faults. • Cases where no fault could be found during a technician’s visit. • Repairs not carried out by our appointed service providers and/or an authorized service contractual partner or where nonoriginal parts have been used. • Repairs caused by installation which is faulty or not according to specification. [. . . ]