User manual WHIRLPOOL 101 237 41 PROGRAM CHART

[. . . ] • Pour a little water into the drip tray (on the first shelf level) to reduce smoke and fat spatters. • Don't forget to remove the plastic handle before closing the oven door and replace it again when removing meat at the end of the cooking time. • • • • To grill large joints of meat (roast beef and other roast meats). The oven door must be kept closed during the cooking cycle. [. . . ] Press “ok” to confirm the end of cooking time. The oven will turn on automatically at the end of cooking time minus cooking time: the indicators on the display above the symbols will light up. Turn knob ᕃ to function lights up next to the symbol . , Keep warm This maintains a constant temperature of 80°C in the oven. The indicator next to on the control panel switches off when a temperature of 80°C is reached, a factory-set time of 5 minutes flashes on the display and an acoustic signal sounds. To change the preset time, use button “+” or “+” “-”. Once the set time has elapsed, the oven switches off, an acoustic signal is heard and appears on the display. Pizza This operates at a fixed temperature of 250°C and is ideal for baking pizzas. The indicator next to on the control panel switches off when a temperature of 250°C is reached, a factory-set time of 12 minutes flashes on the display and an acoustic signal is heard. To change the preset time, use button “+” or “+” “-”. Once the set time has elapsed, the oven switches off, an acoustic signal is heard and appears on the display. Turn knob ᕃ to the self-cleaning Pyrolysis function, and for 2 seconds the display shows clean Cln, the selector automatically sets a minimum time of 1:30. Use buttons “+” “-”, to change duration of the self-clean cycle. The end of pyrolysis time can be set as follows: 1. press “set” to set the end of pyrolysis time. The indicator next to the symbol lights up. Set the end of pyrolysis time using buttons “+” “-”. Press “ok” to confirm the end of pyrolysis time. The oven will automatically turn on at the end of pyrolysis time minus pyrolysis time (set previously). The indicators above the symbols light up. To increase pyrolysis time, press “set” and then set the new pyrolysis time using the button “+”. Confirm by pressing the “ok” button”. [. . . ] To return to the residual cooking time, wait 5 seconds. INSTRUCTIONS FOR USING THE ELECTRONIC TIMER NUTID Timer The timer can only be set when the oven is not in use and allows a maximum setting of 6 hours. The indicator next to the symbol lights up . Use buttons “-” or “+” to set the desired time. Press “ok” to confirm the selection. [. . . ]