User manual WHIRLPOOL 20BIL4A INSTALLATION

[. . . ] Drawer / bottom basket (depending on the model) V. Middle light (depending on the model) D. Snack drawer (depending on the model) G. Crisper drawer moisture control (where provided) I. [. . . ] The freezer compartment remains enabled: it is therefore possible to continue to use it as usual. Light (Water and ice dispenser light) Press the "Light" button to switch the dispenser light on/off. Child Lock (Water / ice dispenser lock) To lock/unlock the water/ice dispenser and related buttons, press the "Ice mode" and "Light" buttons at the same time until the symbol is displayed and the acoustic signal sounds. Specifications, technical data and images may vary from model to model. Eco Mode This function enables you to save energy. To enable the funtion, press the "Fridge temp" and "OK" buttons at the same time for 5 seconds until the display turns off. When the function is activated, the display only lights up and shows the word ECO when you use the appliance or the control panel, otherwise the display will remain off. Remember that this operation does not disconnect the appliance from the power supply. To restore normal operation, carry out the same procedure until the previous temperatures are displayed. D GB F NL E P I GR S N DK FIN PL CZ SK H RUS BG RO QUICK START GUIDE What to do if… Possible causes Noises from appliances are normal since the fans and compressors for controlling its operation switch on and off automatically, for example: • hissing when the appliance is switched on the first time or after a long period. • gurgling when the refrigerant enters the pipes. • humming when the water valve or fan are activated. • rattling when the compressor starts up or when the ice drips in the bucket. • a sudden thud when the compressor starts up or stops. GB Possible causes Solutions Solutions What to do if… The red Blackout Alarm LED and the freezer temperature display are blinking, and the acoustic signal is sounding (if provided). Before contacting the After-sales Service, try to solve the problem by following the advice below. The appliance is excessively noisy Some noises can be reduced by: • levelling the appliance and installing it on a flat surface, • separating and preventing contact of the appliance with the cabinets, • making sure the inside parts are correctly positioned, • making sure the bottles and containers are not touching each other. Blackout Alarm. This alarm activates when there has been an Press the mute alarm button to switch off the acoustic signal. Furthermore, if the appliance door has been left open for a while or if large amounts of food have been stored, the motor will run longer in order to cool down the interior of the appliance. There may be dust or fluff in the condenser. The doors may not be closed properly or the seals may not be intact. If the room is very humid, it is normal for moisture to build up inside the appliance. The air ducts may be blocked. Avoid locations in direct sunlight or near a source of heat. The water filter may be clogged or installed incorrectly. Remove the front plinth (see installation manual) and clean the condenser using a vacuum cleaner. Check that the doors are closed properly and that the door seals do not allow any air infiltration. Install the appliance in a dry, well-ventilated place. Make sure the air ducts inside the compartments are not blocked, as this prevents the circulation of cold air. Check that: • the doors close properly. [. . . ] Replace the bulb (see Instructions for Use, section "Maintenance and Cleaning"). Disable the function (see the Quick Start Guide). Wait for the time required for the system to fill. Disable the function (see the Quick Start Guide). Refer to the filter installation instructions to ensure that the filter was installed correctly and is not clogged. [. . . ]