User manual WHIRLPOOL 20RI-D3L DK INSTALLATION

[. . . ] Glass shelves / racks (depending on the model) T. Drawer / top basket (depending on the model) U. Drawer / bottom basket (depending on the model) V. Internal light (depending on the model) B. [. . . ] • a sudden thud when the compressor starts up or stops. GB Possible causes Solutions Solutions What to do if… The red Blackout Alarm LED and the freezer temperature display are blinking, and the acoustic signal is sounding (if provided). Before contacting the After-sales Service, try to solve the problem by following the advice below. The appliance is excessively noisy Some noises can be reduced by: • levelling the appliance and installing it on a flat surface, • separating and preventing contact of the appliance with the cabinets, • making sure the inside parts are correctly positioned, • making sure the bottles and containers are not touching each other. Blackout Alarm. This alarm activates when there has been an Press the mute alarm button to switch off the acoustic signal. Check extended power failure causing the freezer compartment temperature to rise. The value flashing on the freezer display is the the state of foodstuffs before consuming them. highest temperature reached during the power failure. Press the mute alarm button to switch off the acoustic signal. The This alarm may be activated when the appliance is used for the first appliance needs approximately 2-3 hours to reach the correct time. temperature to store a normal fridge load of food. Replace the filter (see the Quick Start Guide). Replace the filter (see the Quick Start Guide). To replace the filter, refer to the Instructions for Use. The "Anti-bacterial filter" symbol Anti-bacterial filter exhausted (if installed). Make sure the air ducts inside the compartments are not blocked, as this prevents the circulation of cold air. Check that: • the doors close properly. • the appliance is not near a heat source. • the air ducts inside the compartments are not blocked, as this prevents the circulation of cold air. • the "Vacation mode" function is not enabled (see Quick Start Guide) If necessary, lower the temperature. The dispenser does not dispense ice when the lever is pressed. This is normal when the freezer door is open, or if the ice bucket is Close the freezer door and/or check that the ice bucket is installed not installed correctly. The "Child Safety" or "Ice/water dispenser lock" function may have been enabled. Disable the function (see the Quick Start Guide). Excessive moisture inside the compartments. It is not cold enough inside the compartments Change the ice selection from "ice cubes" to "crushed ice" or vice versa (in some models only), so as to remove any ice blocks. If the Ice cubes may be stuck because the ice dispenser has not been used dispenser continues not to dispense ice, wait for two minutes and for some time: The dispenser may not have been used for extended then repeat this operation. periods, causing the ice cubes to stick together. Shake the ice bucket to separate the cubes and increase the holding capacity. [. . . ] Disable the function (see the Quick Start Guide). Refer to the filter installation instructions to ensure that the filter was installed correctly and is not clogged. If installation or clogging is not a problem, call qualified personnel. Reactivate the function by pressing the anti-condensation switch in the ice/water dispenser area (marked with an arrow in the figure), depending on the model. [. . . ]